A Scope rail for a Savage 340

I went out and looked at my stevens 340 and savage 325... neither one is drilled and tapped for a scope mount

the 340 has 2 holes drilled and tapped at the very rear of the receiver for some sort of peep sight

but those rails look fantastic
 
If the base is going to b used with a scope there is no need for all the slots only a few a the front and back for some eye relief adjustments.save lots of time
 
woodchopper said:
I went out and looked at my stevens 340 and savage 325... neither one is drilled and tapped for a scope mount

the 340 has 2 holes drilled and tapped at the very rear of the receiver for some sort of peep sight

but those rails look fantastic
Click to expand...
Damn it. I just checked mine assuming it was D & T for side mount scope base. Mine are the same as yours. I have a 325 and 340 also. Just 2 rear peep site holes. Frig.
 
Nanuk: I’ll be doing another run of these in January. Blued steel has been the clear winner but if you would like one in aluminum Id happily throw one into the mix for you. Pm me if you’d like!
Happy new year folks!
Paul.
 
PR Cook said:
Nanuk: I’ll be doing another run of these in January. Blued steel has been the clear winner but if you would like one in aluminum Id happily throw one into the mix for you. Pm me if you’d like!
Happy new year folks!
Paul.
Click to expand...


That is gorgeous work Paul.

I may have to start looking for a Savage 340 in 22 Hornet.
 
Wow! Nice job!

I need one of these for my Grandfather's old Savage 342 in 22 Hornet! It has one of those old 7/8 th inch horrible Weaver scopes on it!

Will it fit the 342?

Cheers,

Ian

20230103_111335.jpg

20230103_111343.jpg

20230103_111447.jpg
 

Attachments

  • 20230103_111335.jpg
    20230103_111335.jpg
    70.6 KB · Views: 294
  • 20230103_111343.jpg
    20230103_111343.jpg
    64.6 KB · Views: 300
  • 20230103_111447.jpg
    20230103_111447.jpg
    50.3 KB · Views: 293
Ok, my calipers kinda suck, but this is what I could get from them for my model 342.

A = 14.68 mm +/- 0.10 ish
B = 38.40 mm +/- 0.10 ish
C = 14.46 mm +/- 0.10 ish

ID of hole is 3.58 mm +/- 0.10 mm
 
Yep, that should work.
I'll be making a run of these mounts in the next few weeks, I'd be happy to put your name on one if you would like.

Regards!
Paul.
 
PR Cook said:
Yep, that should work.
I'll be making a run of these mounts in the next few weeks, I'd be happy to put your name on one if you would like.

Regards!
Paul.
Click to expand...

Did you ever get around to making more of these scope mounts up? Weather in getting nice out there, and I'd love to be able to put a good scope on the 342 and try it out! Haven't shot it in a very long time!
 
Hey Smit, I'm hoping we connected on this long ago... For the record, yes we have made more and have some available in stock.
Apologies for missing your post.
 
Hey Mogul, We're currently out of stock on these. The next batch is likely going to be late in the year, I can certainly put your name down and let you know when that happens if you like.
 
You must log in or register to reply here.
Back
Top Bottom