Any interest in Cz858 / Vz58 M-Lok Forends?

[p.Rundle]

bonesteel arms upper is pretty good

Spectre, if you make an M-LOK handguard can you please put some placement slots on the bottom so we can mount a forward handgrip

Delete this post, I just saw the 3D model, it's exactly what I wanted to see...

 

[m_kowalski25]

What is your gander on the weight comparisons going to be like? that would be something of interest.

 

[kandress]

Make a full length hand guard and I'd buy one.

 

[Skoal32]

That extended hand guard makes my pants tight. **makes it rain**

 

[Albguy40]

You guys will get a lot of the extended lower hand guards sold I have no doubt about it. Heck if the upper handguard is low enough to cowitness, even if it's lower 1/3 I will ditch my clunky heavy side mount setup!!!

 

[skatemike77]

will buy a upper handguard to mount optics and one that comes off easy enough to clean. cough NEA cough. impossible getting that friggen thing off.

 

[boltman]

Hi Spectre, would you consider at some time designing a replacement handguard for the AR180B's? Midwest Industries did make a tactical handguard but they have stopped production.
Thanks

 

[90vette]

I can not wait for this.. Iol, I'm checking this everyday for a update.

 

[SpectreBallistics]

Here's our latest 3d print. Still calibrating the new 3d printer so it's a bit rough.... I think we might extend it a bit so we can fit 1 more slot. Overall the shape feels good and we think it will improve the feel of the rifle. We will try an bring the prototype to the Fort Mac gun show. Thanks for you feedback on this!

 

[mattcwc]

Longer! Looks good!

 

[mattcwc]

Is there going to be an upper half? As long as the lower?

 

[GreenBob]

Update?

I may have to pick up a VZ if this becomes a reality.

 

[SpectreBallistics]

Is there going to be an upper half? As long as the lower?

We're doing a co-witness upper hand guard. We're hoping we can make it the same length and have it co-witness.

 

[mattcwc]

We're doing a co-witness upper hand guard. We're hoping we can make it the same length and have it co-witness.

Awsome!

 

[Zeek13]

Tagging very interested !

 

[CJackson]

Interested in a model that extends to the bayo lug and allows a proper AFG mount

 

[90vette]

Here's our latest 3d print. Still calibrating the new 3d printer so it's a bit rough.... I think we might extend it a bit so we can fit 1 more slot. Overall the shape feels good and we think it will improve the feel of the rifle. We will try an bring the prototype to the Fort Mac gun show. Thanks for you feedback on this!

I really like the look. I'm hoping you make it longer though. My hand sits naturally beyond the gas block. I heat up my hand quite often.

 

[PrettyBoy]

Any update?

 

[SpectreBallistics]

Any update?

Initial design work is basically done. We will be moving to doing a functional prototype soon.

 

[DT741]

In for sure