I was actually just googling that. Seems like it's a magazine thing and not a gun thing.
auto bolt release
- Thread starter huntinguy
- Start date
I was actually just googling that. Seems like it's a magazine thing and not a gun thing.
Next up , is installing a new extracter, whether it makes a diff , I'm not sure . But it seems to be of the opinion that it does. And you get to pick your action apart some more
Hm my extractor seems to work fine. What does one consider a better extractor to do?
- Location
- West Quebec
That's where I purchased mine..good to deal with as well
Next up , is installing a new extracter, whether it makes a diff , I'm not sure . But it seems to be of the opinion that it does. And you get to pick your action apart some more
A tip about extractor replacements, If it's anyone's first time doing this, get a large clear zip loc bag and dismantle extractor inside bag, little pieces have a habit of flying off into oblivion....
Last edited:
Good point!
I was having a LOT of stovepipes using H3CR mags on my 10/22, I could not go 5 rounds without getting one, ever.
I changed out the extractor for a Volquartsen Custom Exact Edge Extractor and I haven't had a single stovepipe since. I can zip through 20 round loaded mags with zero problems
Now if I can figure out how to solve the problem with FTL when I put the extra 5 rounds in after the 20 rd stripper clip
wayupnorth
CGN Ultra frequent flyer
- Location
- Northern Alberta
on a related note.
i took 3 RIA 10/22's i picked up and i did the mod on them, 2 worked and 1 did not.
i found that the piece itself looks and feels rough to the touch and possibly a bit thicker then the original ruger ones.
i ended up having to sand down the mag release width a hairs width to get the part to work.
i guess they need to be able to run super easy for them to work.
just thought id pass that little nugget of info along in case someone sometime in the future runs into the same problem doing the mod.
i took 3 RIA 10/22's i picked up and i did the mod on them, 2 worked and 1 did not.
i found that the piece itself looks and feels rough to the touch and possibly a bit thicker then the original ruger ones.
i ended up having to sand down the mag release width a hairs width to get the part to work.
i guess they need to be able to run super easy for them to work.
just thought id pass that little nugget of info along in case someone sometime in the future runs into the same problem doing the mod.
