best place to buy molds and powder coating for cast bullets
- Thread starter Woegie7.62
- Start date
...i make my own fishing lures so i have a lot of coating on hand for that...these folks are top notch when it comes to ordering and they are Canadian although i don't know if their pricing is out of line...i just add coating to other items on my order...http://www.luremaking.com
...same is true when it comes to moulds at Higginson
(i also have bought dacron fishing line from Lure Making for making my bowstrings)
...same is true when it comes to moulds at Higginson
(i also have bought dacron fishing line from Lure Making for making my bowstrings)
Not trying to be a wet blanket here, but unless you are an experienced caster, I wouldn't cast for .22 cal. rifles. After 50 + years of casting, I sold all of my .22 casting gear. It can get pretty challenging in the small calibres. Back in the seventies, I assassinated several dozen gophers with a Brno .22 Hornet. I had no trouble getting one inch at 50 yards. Beyond that accuracy went down the toilet in a hurry. Nowadays, I shoot only at a range with 100 yards minimum, and don't need any extra challenges.
So, if you're in an area where you can stalk the wily ground squirrel, then casting for the small bores can be rewarding. Otherwise, I would stick to .30 cal and larger.
So, if you're in an area where you can stalk the wily ground squirrel, then casting for the small bores can be rewarding. Otherwise, I would stick to .30 cal and larger.
Last edited:
