Nordic Marksman just mentioned on another thread yesterday that they're getting 20 or so in about 2 weeks, if they get shipped out on time
Thanks for the info! Gonna have to start getting all the pieces together for a build!
Nordic Marksman just mentioned on another thread yesterday that they're getting 20 or so in about 2 weeks, if they get shipped out on time
Aimpoint T2. Last I checked thats the red dot of choice of the uksf
The guys over at the Reptile House are saying that Obi Wan Nairobi is using a SIG Romeo 4T
Just curious, as to what people are using for a lower, that is also fully ambidextrous, including BCG catch and release from the right hand.
I found a few high-end options out of the Us, Lewis Machine and Tools and Knight’s Armament, howeer, they are not cheap.
Is there an alternative which can available in Canada. I did find that RDSC carries Rainier Arms Lowers which may be what I am looking for.
Rick
Thanks for the feedback.
y
Given that the requirement for full ambi lower seems to show up in more and more major contracts, I am assuming it is only a matter of time before Cold Canada (Diemaco) starts building lowers to compete.
Until then, I think I would look at more cost-effective alternatives.
Just curious, as to what people are using for a lower, that is also fully ambidextrous, including BCG catch and release from the right hand.
I found a few high-end options out of the Us, Lewis Machine and Tools and Knight’s Armament, howeer, they are not cheap.
Is there an alternative which can available in Canada. I did find that RDSC carries Rainier Arms Lowers which may be what I am looking for.
Rick
Those ARTS adapters are sweet, A+ fit and finish on mine really makes the IUR look great! Just curious did anyone tighten them down more then buy hand? The vortex muzzle devices are hand tight but should I be tightening the adapter on more?
Those ARTS adapters are sweet, A+ fit and finish on mine really makes the IUR look great! Just curious did anyone tighten them down more then buy hand? The vortex muzzle devices are hand tight but should I be tightening the adapter on more?
No need to over tighten either. The vortex tightens as you shoot it, and as such will tighten the extender at the same time.
I used anti seize on my original one and it never had an issue.
Now you just need a front sight![]()
Got all the bits to finish my lower yesterday and have it all built up now.
Parts list
-Super 42 braided wire buffer and spring
-Geissele LPK
-BCM PNT Trigger
-Magpul grip
-Gunfighter medium latch C/H
-Radical firearms BCG
![]()
Ran the upper a few times sofar and its slick, but can't wait to try the whole cc unit.
will probably change the magul grip out for a BCM one
![]()