Canuck operator not functioning

[Henryboy]

Got a Canuck operator and it’s a jam o matic tried 30 different types of shells what it does is on the reload it doesn’t center the round and jams on the edge of the chamber going towards the ejection port any help

Hi, having the same problem, did you ever resolve this issue?

 

[rajczak_kashka]

Not surprised at all.

 

[Loyalist]

Are there any burrs or some sort of tool marks on the feed ramp when you pull the barrel? I had a Sulun Tac-12 that looked like the feed ramp was made with a stone chisel.could be getting hung up there and sensing the shell in at an odd angle.....

 

[Henryboy]

Seems to send the shell towards the ejection port instead of straight to the barrel, but I will take it apart again and check... Some other time.

If I ever figure out the problem I will post an update.

 

[Fordtrucks]

Had one of those Rev R4 clones and what a complete pos. First one jammed a little and was missing the mag cap dimple so the mag cap came loose every 5 rds. I sent that one back and the 2nd one the gas cyl threads were stripped out so I had to get a new barrel under warranty. It still jammed constantly traded that turd off. Youll hear reports if these working great but truth is theyre crap

 

[Twan]

Seems to send the shell towards the ejection port instead of straight to the barrel, but I will take it apart again and check... Some other time.

If I ever figure out the problem I will post an update.

If you reach out to O'Dell Engineering, or check their website I think they have a warranty form you can fill out. I don't see why they wouldn't help you out given it sounds like there's an issue.

 

[The_Shmoo]

Give O'Dell a phone call, explain what's going on and I bet big Tony will have you sorted out in no time.