Cast Bullet ####

[hometownhero]

I can seat them out to 3.234" and that is at the lands they are now at 3.175"

 

[propliner]

I can seat them out to 3.234" and that is at the lands they are now at 3.175"

OK, I ran into some trouble with a short throat I guess and had to mill them down a bit.

 

[propliner]

Here's my latest mould from NOE, an 875gr gas check. I think I'll try the powdercoat thing with these.

 

[hometownhero]

Coat those big ones and post some pics.

 

[mbogo3]

I just came from the range with a 1892 Win 44-40 shooting 220gr .430 from Jet Bullets on top of 24gr of RE#7 in Win brass and Win LP primers.Range was flooded so 50 M was max 3 shots off the bench @ .680" Quite pleased with the load but will have to try it at 100 yards before committing to a bulk order.

 

[propliner]

Tried my new mold today. .510" and 870gr

Gas-checked and next to a .44 mag case. These are huge.

All lubed up. I might try some powdercoat with these next time.

Next step: launch them into the next time zone.

 

[f55]

propliner

Beautiful boolits

870gr, T-rex is extincted, unless you know something we dont

 

[propliner]

propliner

Beautiful boolits

870gr, T-rex is extincted, unless you know something we dont

I know T-rex is long gone. I just wasn't sure that the old .500 Jeffery was enough for bear protection so I upped the ante a bit just to be sure. Hard-cast 870gr at 2000fps should be enough, right?

 

[f55]

I know T-rex is long gone. I just wasn't sure that the old .500 Jeffery was enough for bear protection so I upped the ante a bit just to be sure. Hard-cast 870gr at 2000fps should be enough, right?

Only if you hit the vitals, in this case the bears ear hair

 

[SKS50]

Cast up a bunch of my 45 ACP cup points from me NOE mold a while back and got them powder coated in OD and Yellow/Green as well.

The mold also cast some nice HP's as well.

They expand well out of my Hi Point 45 ACP carbine at around 1K fps.

 

[Miago5]

Enfield boolits

https://imgur.com/gallery/v8ygqCV

 

[buckbrush]

2 buckets of fun, they look great.

 

[apu]

660 grain gas checked bullets for the 50bmg

 

[f55]

510gr Slugs

 

[dakotamar]

660 grain gas checked bullets for the 50bmg

Does it need a gas check with powder coating?

 

[f55]

44 mag 275gr

 

[f55]

40 S&W with Lee 175gr mold, these are 180gr

Mix 44Mag and 9mm

 

[propliner]

220 grain plinking loads for .338 Norma.

 

[propliner]

Another fine mould from NOE, a hollowpoint mould for my .500 Jeffery. These bullets weigh in at 450 grains with a hard cast alloy and should hit like an anvil.

 

[buckbrush]

is the 500 Jeffery .500 or .510 calibre ?






/