saskhunter
CGN Regular
- Location
- Sask to B.C.
Hey guys looking for an opinion of some help. I have been loading for a long time and think my methods are sound but i bought a set of collet dies for my 300wsm and when i check the straightness on my case master gauge they sure are not very straight. My brass has run-out of up to 0.006 and when its loaded up the lead can be out up to 0.009. My brass once fired and dirty reads at 0.002 so obviously my dies are the culprit. Maybe its not enough to bother as it is only a hunting rifle and i am shooting 5 shot groups under an inch but it kind of ticks me off that these collet dies are supposed to be really good? everything i read says you should have brass not more that 0.003 out? 