CZ 455 rings
- Thread starter 243jimb
- Start date
Much depends on the scope you are mounting. Is it a Nikon? If it is you may need high dovetail rings to allow the high bolt throw to clear. If not there are a lot of medium rings that should do the job with scopes that don't have an especially large ocular bell.
Burris rimfire highs gives you tons of clearance, mount virtually any scope. They are a drastic step up from the mediums which I do not think would be suitable for anything above a 9x40. They really should make something inbetween medium and high.
Here is a link to some comprehensive information about your inquiry, RFC is your friend
http://www.rimfirecentral.com/forums/showthread.php?t=336921
Here is a link to some comprehensive information about your inquiry, RFC is your friend
http://www.rimfirecentral.com/forums/showthread.php?t=336921
crasheralex
Regular
- Location
- Cambridge, On
I've got a CZ455 varmint and am looking at getting a nikon prostaff 2 rimfire 4-12x40. Would the standard cz ?medium? Rings work?
mastermind
CGN Regular
- Location
- SW Ontario
Burris Signature Rimfire 1" (P/N 420554) clears the bolt with a Leupold VX-2 Rimfire 3-9x33mm EFR scope. This is the ultimate combo for my 455. I am not a fan of high mounted scopes/rings.
When I bought my CZ 455 American a few years back I stopped in at the local Wal*Mart and bought a pair of Weaver 1" Tip-Off mounts, if there was a height on the rings I forget but they are not very tall. However the bolt handle clears the Bushnell 3X9 in the back and front bell doesn't come in contact with the barrel.
Mumbles Marble Mouth
CGN Ultra frequent flyer
- Location
- Lower Mainland
Leupold scopes is the only scope I could ever mount on a CZ. They're eye piece are the smallest with their rimfire scopes eye piece being the smallest. Its the only scope company you can get away with using mediums for their standard scopes and even lows on a CZ as long as its the VX Rimfire. Everything else just looks goofy.
Burris rimfire highs gives you tons of clearance, mount virtually any scope. They are a drastic step up from the mediums which I do not think would be suitable for anything above a 9x40. They really should make something inbetween medium and high.
Here is a link to some comprehensive information about your inquiry, RFC is your friend
I think these rings pictured are too high
Tally as well.
Note how I think there should be a size between burris medium and high, and these rings were bought for a scope with a larger objective that would not have worked with the mediums. Pic was taken at a time when I was trying a different, proven scope when trying to figure this rifle's accuracy issue. I knew they'd be higher than I needed but after being to three different stores with no luck these were the only ones I could be sure would fit the scope. I'm fine with them.
