Daniel Defense LPK+Spikes lower=Problems
- Thread starter shotzee
- Start date
- Location
- 54°52'56"N 112°10'7"W Alpha Bravo
Im assuming this is a billet lower?
angryeyebrows
CGN frequent flyer
- Location
- Oscar Mike
The grip screw does not fit? Why would spike's not use a standard AR thread? Weird!
The parts being new and all, newly cut threads and the anodizing to the receiver makes for a difficult fastening. Try working the screw into the receiver without the grip to see how and where it's binding. Of course, don't cross thread it.
The only difference I know of is the length of the screw shaft between the early M16 pistol grips and the later enhanced pistol grip with the finger bump.
The enhanced grips have a shallower base and require a shorter screw. M16 pistol grips can accommodate a 1/4" longer screw having a thicker base.
Earlier lower receivers had the grip screw hole drilled right through. A screw being too long would interfere with the trigger.
Grip screws are 1/4" x 28NF.
The only difference I know of is the length of the screw shaft between the early M16 pistol grips and the later enhanced pistol grip with the finger bump.
The enhanced grips have a shallower base and require a shorter screw. M16 pistol grips can accommodate a 1/4" longer screw having a thicker base.
Earlier lower receivers had the grip screw hole drilled right through. A screw being too long would interfere with the trigger.
Good god! For a single 1/4-28NF screw?
Should have went to some local industrial supply place, they likely would have given you it for free rather than do the paper work to bill it.
