delete

The rail is not centered to the bore. Where you at? I have a jig that centers it to the bore of the rifle. If you're not in BC and dont mind sending it to me i'll take care of it for you

Ante
 
Oldsmobiler said:
The rail is not centered to the bore. I have a jig that centers it to the bore of the rifle.
Ante
Click to expand...

I thougt the new taper screws were supposed to solve this?

It could also be a ring or scope mounting issue. Do you have another optic/rings to try it with? Are you using good rings tightened properly?

On mine I mounted a XTR scope in ARMS rings. Windage was dead-on! Could be luck but I think it's a proof these 3 manufacturers know how to make something straight!
 
I used a torque driver to 15in/lbs on my ARMS 22 low rings. Seems like a scope issue to me. Or to make sure it's not you, you could try another shooter.
In the optic forum you may get better ideas.
Good luck.
 
theiss said:
WildPhil,

I got an ARMS 22 rings (low).
I think it's pretty tight. I'm afraid to tighten it further.
As it is right now, I sometimes get the "haze"; but it could me my astigmatism...
I had put on a Springfield Armory Government model 6x40mm scope in summer, but I don't remember what the result was. I got tighter group on it, I think, and that's why I contacted Korth to send the scope out for check up.

Oldsmobiler,
I'm in Coquitlam.
and yes, I also got the tapered screw with my scope base.

T.
Click to expand...

If you want we can plan a time when we could meet up at the range and you can try my scope and rings off my M25.

Gotta see how the new tapered screws work
 
You must log in or register to reply here.
Back
Top Bottom