Dlask barrel + Dlask reciever = tight fit

nutmik

nutmik

Regular
Rating - 100%
247   0   0
Location
East Kootenays
Hi All,
Just trying to fit my Dlask barrel to my Dlask reciever and it's extremely tight,
What's the best way to get these together and lined up properly ? It feels like I will have to use a fair amount of force to get them together and am worried that when the barrel is all the way in the reciever, if it's not perfectly aligned, I won't be able to turn it. Any suggestions ? grease?, hammer?,emery cloth?
I did a search but couldn't come up with anything.
Thanks in advance...Mike
 
nutmik said:
Hi All,
Just trying to fit my Dlask barrel to my Dlask reciever and it's extremely tight,
What's the best way to get these together and lined up properly ? It feels like I will have to use a fair amount of force to get them together and am worried that when the barrel is all the way in the reciever, if it's not perfectly aligned, I won't be able to turn it. Any suggestions ? grease?, hammer?,emery cloth?
I did a search but couldn't come up with anything.
Thanks in advance...Mike
Click to expand...
send it back ask them to sell you one thats in spec
bbb
 
the dlask 10/22 barrels are all tight, but once it went on I had no complaints. I put the barrel on a ruger receiver by placeing the receiver firmly (be careful not to put too much force on it) in a padded vice and heated it with a heat gun, barrel then slipped right in. I was very happy with mne once installed, Dlask makes a great barrel.
 
gallen270 said:
the dlask 10/22 barrels are all tight, but once it went on I had no complaints. I put the barrel on a ruger receiver by placeing the receiver firmly (be careful not to put too much force on it) in a padded vice and heated it with a heat gun, barrel then slipped right in. I was very happy with mne once installed, Dlask makes a great barrel.
Click to expand...

in addition to this, put the barrel in the freezer before hand. i bet it will fall right into place.

be prepared some difficulty if you want to take it apart however...
 
Jahred.F said:
in addition to this, put the barrel in the freezer before hand. i bet it will fall right into place.

be prepared some difficulty if you want to take it apart however...
Click to expand...

Thats what I did, I didnt use heat cause I was worried about warping. I just put the barrel in the freezer, left it there for a couple of hours (cause I had other things I needed to do) came back and it slid right in.

Cheers
 
Thanks for the advice guys, it worked great ! Pieces went together just like they were made for each other!, Now if the trigger bits would just arrive.........................................
Mike
 
You must log in or register to reply here.
Back
Top Bottom