Finally, My Tikka CTR in 308!

1. Atlas bipod and rail attached to the sling swivel stud. no mod.

http://www.accu-shot.com/

2. APA Little Bastard brake Gen II

https://www.americanprecisionarms.com/products-page/muzzlebrakes/gen-ii-little-bastard/

3. 1-> Wolverine Supplies 2-> Prophet River Firearms
 
awesome thanks so much.

Which model Bipod is that and what is the rail used? I'm searching the site but I don't see anything for a single stud. TIA.

Just picked it up tonight - I love how the bolt slides like silk! Looking forward to getting it out to the range this week.
 
Last edited:
Well I picked mine up and mounted a Bushnell 10x Elite Tactical. Only fired 10 rounds through it, my first impression....impressive! first round was on for vertical but 6" off the horizontal to the left. I dial in the Bushnell and proceed to stack a 3 round group 1/2" left of center and low by 1/2", I make one more dial and stack 3 rounds in the bullseye overlapping. I send the next 3 rounds at the 300 gong and ping it each time. Using federal matchking 168 grain. I only have good things to say about this beast, looking forward to the next time I get it out.
 
Brian46 said:
That is why I plan to have one re barreled to a 16" light profile fluted barrel specifically for the purpose of hunting
Click to expand...

I thought it was illegal to go under 18.5" if it's not from the factory. Or is it all good if the barrel you buy is manufactured at that length?
 
Tikka223 said:
I thought it was illegal to go under 18.5" if it's not from the factory. Or is it all good if the barrel you buy is manufactured at that length?
Click to expand...
exactly, you can't legally cut one that short, but someone can make a new barrel any length you want as long as you do not go under 26" over all.
 
brad555 said:
Looks like they weigh just over 7 pounds from what I have read, with the medium weight barrel only 20 inches long how does it balance say compared to a composite stock 24-26 inch sporter weight barrel? Does it feel much heavier? I am considering one for a carry around hunting rifle but don't want to get to heavy.
Click to expand...

I have a Tikka CTR in 308 and it weighs 9.14 lbs with Warne rings and a 2.5-10x32 Vortex PST scope, my Tikka Lite Battue in 308 weighs 7.286lbs with Warne rings and Leupold 1.25-4x Leupold VX-R scope
 
its an Accu-Shot BT 10 Atlas Bipod and to mount it just buy a sling swivel stud picatinny rail adapter.
The rear monopod is also an Atlas.
Not a suppressor, its a muzzle brake and its a little bastard 2 muzzle brake. Not really needed for a 308 but its nice to see your impact especially when shooting out to 900 yards or so.
I cant remember what sotre I got #2 from, but it was a CGN sponsor for sure. the monopod and bipod, Wolverine'
Jafacakes said:
Nice! I pick mine up tomorrow ��
A couple of questions,
1. What bipod is that? And did you need to do any modifications to install?
2. What brand of flash suppressor?
3. Oh and where did you get 1. And 2.

Cheers
Click to expand...
 
Roddy said:
What carrying case is that? Looks like a Voodoo 42" or something. Do you like it?
Click to expand...
Yes, I believe that it is a Voodoo 42". I now use a hard case for this gun. I have found the soft cases rub the paint finish off on any protruding scope (windage and elev knobs) and/or accessory parts over time.
 
You must log in or register to reply here.
Back
Top Bottom