Got my XCR, pic and first impressions!

DMS1

CGN frequent flyer
Rating - 100%
130   0   0
Location
Southern Ontario
Lots of firsts here for me, my first black gun, first purchase off EE.

myxcr.jpg


Gun arrived Friday, had to go with taller rings than I wanted (18mm saddle height, should switch to 14-15mm). Scope is a Bushnell Elite 4200 2.4-10x40 with firefly reticle. After the scope was mounted, I sighted at 25 indoors, then got a chance to shoot a few outdoors at around 100yrds. My thoughts are:

1) Trigger - WAY too heavy, but since I have an enhanced trigger on the way, I did the set screw adjustment, but left the arm shy of the safety hole so I would not have to grind anything. I got a little better. Should have enhanced this week. Accuracy was OK, 1.5" at 100yrds, new trigger should get it better. I did manage to put three shots through the same hole at 25 yards.

2) Weight - I like the looks and the accuracy of the heavy barrel, but the light would probably be sufficient. The gun as pictured weighs 9.75 lbs. I will be getting a 6.8 barrel for deer hunting and will be walking with the gun alot, so I am leaning towards light barrel for that. I still have to add front sling mount and bipod (only for target or calling yotes). Also, pretty front heavy

3) Stock - this is the 13" LOP tubular stock. It is too short for me and I am not large. I am going to make a .5" to 1" aluminum spacer to go between the rubber pad and the stock.

Misc - the ergos are great for the controls, the trigger guard plate rattles, I have a winter version coming in with the trigger, I will try to get it to not rattle when I put it on. It has a little more play in the hinge than I would like, may try to shim it later, but very easy to service/clean.

Will try calling for coyotes with it tomorrow. Thanks savage10 for the sale, I will leave you feedback!
 
I installed the new trigger in my earlier generation XCR which I also bought on the Exchange forum. WAY better,....totally different trigger.
 
Can you explain the XCR's 2 stage trigger because it doesn't feel like one to me?

squeeze until you feel it click. be delicate. hold that pressure until you are ready to fire. the remaining trigger break is very light.
the whole above explanation can be missed, as the trigger pulled the whole way through is very crisp and light. if you didnt know you could easily miss it. go easy and slow. my serial number is only 600ish, and it has the 2 stager.
 
My XCR is from the last shipment that Wolverine received I just got it 2 weeks ago hadn't noticed this on the trigger I'll have to go give it a try...
 
Back
Top Bottom