MosinNagantM44
CGN Ultra frequent flyer
- Location
- GVRD
I want Chicom C-96 in 9mm.
Ideas for Dominion Arms
- Thread starter Sniper1
- Start date
evolture
CGN frequent flyer
- Location
- Langley, BC
marstar(?) imported some 5.56 SKS's that were garbage. I think every one agreed that these would not be tried again.
Not much kick on that mare's leg, but it WOULD sell pretty well.
I think trapper length winchester clones was suggested last year, but a mare's leg with two rear stocks(one short, one full) would be fun!
CanAm
Canada Ammo - CGN Sponsor
- Location
- Vancouver, BC
In order to clone any gun, we need a market, and drawings. Neither are likely.
If I were to find some blueprints for you...
CanAm
Canada Ammo - CGN Sponsor
- Location
- Vancouver, BC
Yes, of course a full set of dimensioned and tolerances drawings goes a long way, assuming there is also a good market.
rally guy
CGN Ultra frequent flyer
While everybody is trowing ideas, could this be possible in the near future
http://world.guns.ru/shotgun/sh39-e.htm
semi-auto grizlly
http://world.guns.ru/shotgun/sh39-e.htm
semi-auto grizlly
mmattockx
CGN Ultra frequent flyer
- Location
- Done with sheeple
tactical lever
CGN frequent flyer
- Location
- Fox Creek, Alberta
Short truck/brush gun
How about a bolt action with a 12 or 14 inch barrel in 30-30 or 7.62x39, with some 10 round mags? Or a traditional lever (tube mag), but parkerized with a 12 or 14 inch barrel in .357-454 casull or 460 S+W. Something really short, rugged, but useable that doesn't cost a lot to feed. A few have mentioned the mare's leg, but I'd prefer a full size butt stock. I can cut it or replace it if I feel the need to go shorter. The lever might have some traction with the cowboy's too. If you made that, (.357 preferably) my card would be out so fast it would smoke!
"What are you buying? Better not be a gun!"
"Quiet woman! I'm trying to make a transaction here!" (Ducking)
How about a bolt action with a 12 or 14 inch barrel in 30-30 or 7.62x39, with some 10 round mags? Or a traditional lever (tube mag), but parkerized with a 12 or 14 inch barrel in .357-454 casull or 460 S+W. Something really short, rugged, but useable that doesn't cost a lot to feed. A few have mentioned the mare's leg, but I'd prefer a full size butt stock. I can cut it or replace it if I feel the need to go shorter. The lever might have some traction with the cowboy's too. If you made that, (.357 preferably) my card would be out so fast it would smoke!
"What are you buying? Better not be a gun!"
"Quiet woman! I'm trying to make a transaction here!" (Ducking)
You mean an AR-16?...
CanAm
Canada Ammo - CGN Sponsor
- Location
- Vancouver, BC
Ar-160b
If you're going for the Canadian market, M14 mags would probably be best.
P12
CGN frequent flyer
- Location
- Georgetown
If this actually arrives here in a NR configuration which I think it should, the receiver looks different than on the 1100 clone, I will buy one and a bunch of mags.
