Info needed on SKS bipod
- Thread starter DILLIGAF
- Start date
boltonscouter
CGN frequent flyer
- Location
- parts unknown
I thought of that or maybe JB Weld? I figure I'll need to fill it pretty good to get enough support to handle the repeated recoil on the swivel stud and get good bonding. Might rough it up a bit inside with a dremmel to get a good rough surface. I suppose the exposed filler in the bayo slot could just get a coat of black paint. Might add some weight to the front end but who cares? It's on a bipod
Couldn't mount the bayo in the closed position anymore even without the bipod so it's either sans bayonet or full charge
Couldn't mount the bayo in the closed position anymore even without the bipod so it's either sans bayonet or full charge
fat tony
CGN Ultra frequent flyer
JB Weld is considerably stronger than the auto body filler. Other than Acraglass, there is a product from 'Solderit' that allegedly works on abs car parts. Probably better to sand the cutout, maybe vee it out a bit, and fill with JB weld (like you have already said). We all know JB Weld gives good repeatable results.
Last edited:
300Spartans
CGN Ultra frequent flyer
- Location
- Canada of course
A guy I knew had one of the Norinco clamp-on bipods on his SKS. It was junk, pure and simple, and it scratched the hell out of his barrel. Avoid.
Get something to rig a Harris onto it.
Get something to rig a Harris onto it.
