Some production lots of the IVI 9mm are hotter than others. I've heard that at the Ammunition Depot level they try to parcel out the lighter lots
for pistol usage and the heavier for the SMG usage. Of course, the C1 is little-seen in the field today...
I hadn't heard that DND was acquiring any different NATO-spec 9mm ammunition,
so chances are the SIG's are provisioned with IVI ball too...
IVI ball is actually fairly good ammunition (as FMJ goes), but realize that the remaining Browning pistols
in the system are probably over 40 years old. It would be an unusual unit that's very tight tolerances today.
That was one of several factors that motivated the buy of SIG 226's.
Not necessarily true. There are days gone by when military ammo was given away to civilians at matches, and other cases where ammo was sold in the US and re-imported. This is why you'll notice that most of the stuff floating around in civilian hands is all from the same few lots.BTW, these are manufactured for the DND and AFIAK they were never sell for surplus. So you probably are in possession of stolen DND property. Just sayin...
BTW, these are manufactured for the DND and AFIAK they were never sell for surplus. So you probably are in possession of stolen DND property. Just sayin...
I've chrono'd some IVI 9mm from a Glock 17 and it was fairly consistant with an average MV of around 1350 fps -fwiw.
I found the same thing, I believe the cartridge is +P+.
The SAAMI pressure limit for the 9×19mm Parabellum is set at 241.32 MPa (35,001 psi) piezo pressure.[20]
The SAAMI pressure limit for the 9×19 mm Parabellum +P is set at 265.45 MPa (38,500 psi) piezo pressure.
The service pressure Pmax of the 9 mm NATO is rated at 252 MPa (36,500 psi) where C.I.P. rates the 9 mm Luger PTmax somewhat lower at 235 MPa (34,100 psi). The 315 MPa (45,700 psi) proofing test pressure used in the 9 mm NATO proof test however equals the proofing test pressure used in the 9 mm Luger C.I.P. proof test.