LAR-15 223-556 Stainless 10 Round pistol Magazine in Canada 23.94USD
- Thread starter IRUNGUNS
- Start date
So it would appear that it is a manufacturing issue with accurate tolerances not being maintained. I also have 4 on their way and will report back. IRG's...it would be nice if you could provide some feedback on the obvious issues some have been experiencing.
the 4 I have wont seat on a closed bolt at all and there is zero play after the 10th round. In fact if you tap the side of the mag hard enough the 10th round will actually pop out. I contacted IRG, but they haven't replied back yet. The mags do feed properly....
mine inserts on an open bolt on a Colt LE6920, Drops free no problem.... On my Tavor X95 it's a completely different issue. It will only insert on an open bolt aswell, but its extremely tight inserting it, and will not drop free all the time. Its like the mag is thicker then normal or something. Haven't had much time to investigate that issue.
Every mag inserts on an open bolt (as long as it fits). Of course, an open bolt is not blocking anything. A good magazine should insert on a closed bolt then cycle correctly.
If a magazine doesn't insert freely on a closed bolt, it's like a pistol magazine that wouldn't insert unless the slide is pulled back. No one would ever consider that magazine is fully functional. Same for an AR.
If a magazine doesn't insert freely on a closed bolt, it's like a pistol magazine that wouldn't insert unless the slide is pulled back. No one would ever consider that magazine is fully functional. Same for an AR.
Agreed. Just received my 4 today. Not range tested however 1 of 4 insert on a closed bolt and feed properly ran 3x through. 2nd will sometimes seat on closed bolt with 10...2 out of three times the follower will jam. 3rd mag 10th round very tight and will not seat on closed bolt without locking follower on crimp....a 9 round mag apparently. 4th is just plain dangerous with FTFeed and jambs on each load. I have sent IRG a message regarding this, my first purchase from them...not exactly excited my the feedback I am seeing in here regarding responses either. Anyone have some customer service tales to share? So much for quality control.
Last edited:
just got my response back from you guys and I'm more then happy at the solution to this issue that they offered me. I wont mention the solution that was offered as I don't know what was offered to other people and I don't want to cause an online hanging. But I believe it is more then fair.
I've made roughly 10-15 orders with you guys and only had one issue and that was with 1 magazine being pinned improperly. Contacted you guys, was emailed a prepared shipping label, and had a replacement sent right away. Issues do happen with new products, these were crimped by the manufacture not IRG. I believe they are handling this issue properly. If you have an issue contacted them.
I've made roughly 10-15 orders with you guys and only had one issue and that was with 1 magazine being pinned improperly. Contacted you guys, was emailed a prepared shipping label, and had a replacement sent right away. Issues do happen with new products, these were crimped by the manufacture not IRG. I believe they are handling this issue properly. If you have an issue contacted them.
What did they offer? Better say here than have them receive 5 gazillion emails, that's what a public forum is made for.
youve obviously never used a 30rd magazine lol
You read my mind lol. Always difficult to seat a full 30rd on a closed bolt.
I have. But a good comparison in this case is that it would be hard to seat the 10th round in a 30 rounds mags.
not at all, the magazine is mechanically crimped, the follower is bottoming out against solid steel, not a spring..
