M&P-22 Thread Protector
- Thread starter KITIMAT TOM
- Start date
ns_redneck
Regular
- Location
- New glasgow
i was looking at that the other day wondering if it comes off. i couldn't see a way without scratching it all up.
Just looked at mine - Nope no flats on it for the wrench - WTF hey ? lol RJ
Good Day
Dose your M&P-22 have a slots in the thread protector to be removed with supplied wrench?Mine dose not.Is this to comply with Canadain law?I would like to remove it at some point to lubricate barrel threads against rust.
Yep, Canadian law requires that it be permanently attached. Remove it, you'll then have a barrel that's less than 105mm.
Outback2970
Member
- Location
- Nova Scotia
Mine is the same with a spent casing date of Nov 2014 so I guess it's nothing new. I may never have even noticed if not for this thread. Wonder why we still get the wrench?
wayupnorth
CGN Ultra frequent flyer
- Location
- Northern Alberta
is it actually permanently attached?
how?
ive got one and never looked at it but now im curious just for curiosity sake.
red lock tight?
wayupnorth
CGN Ultra frequent flyer
- Location
- Northern Alberta
got out the calipers.
barrel with cap on is 107.09mm
i measured back from the end of the cap to the end of the barrel (inside) and that is 2mm
so without the cap on the barrel looks to be 105mm plus a little.
so wow this barrel is close without the cap on.
id really like to take it off to get the exact measurement.
barrel with cap on is 107.09mm
i measured back from the end of the cap to the end of the barrel (inside) and that is 2mm
so without the cap on the barrel looks to be 105mm plus a little.
so wow this barrel is close without the cap on.
id really like to take it off to get the exact measurement.
lol RJ
- Location
- Blaster land, Okanagan BC
Don't do it, think of the children lol!
