Modern Sporter Update April 16 2019
- Thread starter alberta tactical rifle
- Start date
- Status
That is correct, however, I’m sure if someone with the thicker hook, could easily remove a small amount of material to accommodate the couple of triggers that don’t fit.
The hook is very meaty( for lack of a better word) and removing a small amount from the bottom of it should be fine.
But it may void warranty
ATRS Shaun
Business Member Rep.
- Location
- Calgary, AB
No they will not be. They will be referred to as Gen 1.11427B.
Gen 2 is early in the theoretical planning stages, looking into an alloy of Rarified Energon and cybernucleic acid, offering a potential 98% weight savings for hunters as the gun will literally carry itself. Have to wait for NASA to get back to us to see how the supply is but it's safe to assume it'll be very, very expensive.
And yes. You were just trolled. There are no generations, just modern sporters.
- Location
- calgary alberta
To date 4 that we know of. With the revision of the hook angle it is not required so going forward the rear TD pin will still be a fixed in place pin.
Altering the hook slightly is a far better way to deal with the few triggers that are the source of the problem.
- Location
- calgary alberta
That is correct, however, I’m sure if someone with the thicker hook, could easily remove a small amount of material to accommodate the couple of triggers that don’t fit.
The hook is very meaty( for lack of a better word) and removing a small amount from the bottom of it should be fine.
But it may void warranty
This should never be a warranty problem. Assuming someone does not go full blown retard with the power tools that is. To put an angle on the hook station should not take more than a few passes with a file. But do keep in mind warranty expressly does not cover "stupid" and we all know there are guys out there that should under no circumstances be allowed to work with anything more complicated than a spork.
ATRS Shaun
Business Member Rep.
- Location
- Calgary, AB
"Soon"
Well I ordered one, suppose I'm in run #3 and I'll be waiting a while. Hope no laws change in the meantime. Almost done my MD SLR build now, had some issues hope you guys put out a better quality product than them! I've heard you're top notch. Cheers.
I doubt you will be disappointed, there is NO comparison between what ATRS builds and what Crapabee pukes out and calls high quality product.
Hopefully C71 gets drawn out until the election and the turd gets flushed. This should be the end of this useless nonsense that attacks the law abiding but favors further criminality.
Lowers should be in production now, and if the timelines they had set are still on point... septemberish? Is what I recall for finish.
The SS uppers though won’t be done until the new year if I’m not mistaken.
- Status
