MRA Renegade Rifles, Parts, and Kits now available

......................

It will come with the standard end plate but you will be able to purchase the A2 plate for the Renegade or Maverick within a couple weeks, The plates are already in process and they will be $9.95.

If you could please let us know when these plates are available I would very much appreciate it, or I would be prepared to do a pre-order, I would take 3 plates

Thx

AbH
 
If that happens, we'll do you one better and make proprietary 20 round mags. After all, it's a bolt action rifle.

On the topic of proprietary magazines, is it possible to make the max COAL support 2.87 inches or longer for the proprietary Maverick magazines if you do decide to go that route? I know some AR-10/SR-25 pattern magazines can fit cartridges up to 2.90 inches COAL; if you can make them that would be amazing.
 
On the topic of proprietary magazines, is it possible to make the max COAL support 2.87 inches or longer for the proprietary Maverick magazines if you do decide to go that route? I know some AR-10/SR-25 pattern magazines can fit cartridges up to 2.90 inches COAL; if you can make them that would be amazing.

Great idea and I dont see why we couldn't do this.
 
There is no dust cover on either side.

Not dust cover like the typical dust cover. One that covers dirt and such for when someone has the charging handle on the ejector side. Serves no purpose other than cosmetic covering the unused slit
710x528_27901035_15078103_1560388318.jpg
 
Anyone tried the JP Silent spring in their Renegade? Had a pile of problems with the standard spring installed from the factory today; would not fully go into battery. The spring, barrel, and bolt had all been tested on an AR and worked flawlessly.
 
Anyone tried the JP Silent spring in their Renegade? Had a pile of problems with the standard spring installed from the factory today; would not fully go into battery. The spring, barrel, and bolt had all been tested on an AR and worked flawlessly.

There should be no problem with the factory installed spring. All factory guns are test fired. Please email info@mapleridgearmoury.com and we can help resolve the issue.
 
We are making several hundred and we will post here and on our social media when they are available.

Good morning to the MRA team!

I hope this note finds you all well…

Is there any update to win these plates will be available please I have three bills that required

Thank you for your time and attention to this matter

Warmest regards

AbH
 
My rifle is one of the receiver kits that I have swapped parts from an AR to get up and running. This was not a full rifle from the shop. That said, it is a Wilson Combat barrel and Daniel Defense bolt tjat mated perfectly before. I am asking if anyone has tried the JP silent spring assembly and if they have had problems.
 
I am pulling it back as hard as I can and letting it go. Same as I do with my pistols.

Silly question but did you remove the gas rings? and I also had an issue with one of my barrels not working on the rifle but seemed to work when installed on a AR upper.
 
Just pulled the bolt off the AR BCG and dropped it onto the Renegade BC. Am I supposed to remove the gas rings?

Sure hope it is not a barrel issue. Whole point of this thing was to salvage a really good barrel. Thing is worthless to me if it does not work with this barrel.
 
Back
Top Bottom