My SKS bubba project
- Thread starter nikai
- Start date
Been looking at your chassis on GP and I'm curious how much stress can the 1913 rail the stock attaches to handle before it fails?
Same question goes for the pistol grip as well.
Your GP post mentions heat resistance but has that been tested?
I run my SKS's pretty hard when I take them out so curious how tough this chassis is, your other products I've bought in the past have been A+.
"Your GP post mentions heat resistance but has that been tested?"
Yes, 200 rounds test with enough break between just to replace magazines. There is A LOT of air between the lower hand guard and the barrel and that's the part that gets the hottest. If it was sitting directly on the barrel, it would likely be a different story.
Things change if you go to -10c and lower, then it becomes more brittle. Still strong, but more brittle.
Yes, 200 rounds test with enough break between just to replace magazines. There is A LOT of air between the lower hand guard and the barrel and that's the part that gets the hottest. If it was sitting directly on the barrel, it would likely be a different story.
Things change if you go to -10c and lower, then it becomes more brittle. Still strong, but more brittle.
Big bore dinosaur
CGN frequent flyer
- Location
- NORT OF COW.TOWN.EH
Nice and clean. Lools good gunnie
