NEA XCR Stock Adapter Gen 2

I would like to get one,..but apparently WOlverine never recieved any of the shipment? I would also have like to get one thru Neit arms, but apparently sold out.....so who else recieved some?,....I would like to get one.
 
NOTE - Nov. 30, 2010

We now have the Followign Stock adaptters available In-Stock, ready to ship:

NEA Gen. 1 Drop Tang AR-15 Stock Adapter - $75.00

NEA Gen. 2 In-Line AR-15 Stock Adapter - $75.00

NEA Folding Stock Adapter for Factory Skeleton Stock - $119.00
 
just emailed you with my info Bryce,...I will call with my visa # this afternoon to complete the transaction.
 
I just finished installing this same adaptor on my xcr, and find that the mounting screw hole on the adaptor is positioned too high. As a result, the adaptor does not sit flush with the gun. It is about 2-3mm too low. Anyone else have this issue?
 
Master Chan said:
I just finished installing this same adaptor on my xcr, and find that the mounting screw hole on the adaptor is positioned too high. As a result, the adaptor does not sit flush with the gun. It is about 2-3mm too low. Anyone else have this issue?
Click to expand...

It's probably not the adaptors fault. There was another member who had the same problem. It turned out that Robinson made a batch of bad receiviers with the stock threads in the wrong location. Rather than scrap them, they built matching out-of-spec stock adaptors to match.
 
Stevo said:
It's probably not the adaptors fault. There was another member who had the same problem. It turned out that Robinson made a batch of bad receiviers with the stock threads in the wrong location. Rather than scrap them, they built matching out-of-spec stock adaptors to match.
Click to expand...

I only have one thing to say about that. "Boooo."
 
Master Chan said:
I just finished installing this same adaptor on my xcr, and find that the mounting screw hole on the adaptor is positioned too high. As a result, the adaptor does not sit flush with the gun. It is about 2-3mm too low. Anyone else have this issue?
Click to expand...

Turned out mine was like that as well :(
Going to see if I can get a "special one" made to order.... gonna see how that works out....
 
Check with Charles Martel. IIRC he made an adaptor that fits the wonky XCR receiver for the first guy who reported the issue.
 
Master Chan said:
Hi, Charles. Can you tell me where I can buy one for my XCR with the wonky receiver? Thanks!
Click to expand...

is yours off as well? We are planning to run another batch in Jan so anyone who needs one made, pm "north eastern arms". What we need to establish whether there are two heights or if robinson let out a pile of guns with all different height off sets..... which would be pure gong show to let something like that out.
 
Finally got around to installing my NEA gen 2 adapter last night, I had sent it to Synergy Coatings in Nisku, Alberta to get it OD green Cerakoted then other projects like selling my house finding and buying a new one got in the way that is until yesterday when my CTR/buffer tube/nut arrived from Blaxson.

I installed it all and it looks and feels very great I especially like not having my nose rubbing against the small sling loop ring on the factory adapter then I noticed that the NEA adapter doesn't line up perfectly it is sitting a couple mm low...

Its not perfect but it isn't enough out to worry about either especially after sinking the time/money into getting it Cerakoted...

CC
 
You must log in or register to reply here.
Back
Top Bottom