Need a little help 45 90 Marlin Ballard

MJB78

Member
Rating - 100%
3   0   0
My Ballard that I bought was supposed to be 45 70. I did a chamber cast and cast the bore also and it is definitely 45 90.
I bought some starline brass and it will not fully chamber. It is just a tiny bit to tight. I trimmed the end off a case and that did nothing so it is not the length. I have hornady 45 70 brass and it goes in nice and snug. I do not have a 45 90 sizing die right now. Do you think that will fix this issue?
Sadly I was dumb and bought 45 70 dies and brass before I realised the gun was not what I was told. Lesson learned
If anyone in Central AB has a 45 90 sizing die and would be willing to run a couple of my starline brass though the sizing die I would be super grateful so I can see if this is going to work before I buy the dies. Message me if so. lol I thought I would already be out on the range by now with this gun. At least it is nice to look at. haha
 
Have you tried lubing a 90' case and running it into your 45-70 dies? The last 3/8" won't go in the die but might indicate that factory brass can vary in size and a few thousands oversize could be the problem.
 
Back
Top Bottom