Need a little help 45 90 Marlin Ballard

MJB78

Member
Rating - 100%
3   0   0
My Ballard that I bought was supposed to be 45 70. I did a chamber cast and cast the bore also and it is definitely 45 90.
I bought some starline brass and it will not fully chamber. It is just a tiny bit to tight. I trimmed the end off a case and that did nothing so it is not the length. I have hornady 45 70 brass and it goes in nice and snug. I do not have a 45 90 sizing die right now. Do you think that will fix this issue?
Sadly I was dumb and bought 45 70 dies and brass before I realised the gun was not what I was told. Lesson learned
If anyone in Central AB has a 45 90 sizing die and would be willing to run a couple of my starline brass though the sizing die I would be super grateful so I can see if this is going to work before I buy the dies. Message me if so. lol I thought I would already be out on the range by now with this gun. At least it is nice to look at. haha
 
Have you tried lubing a 90' case and running it into your 45-70 dies? The last 3/8" won't go in the die but might indicate that factory brass can vary in size and a few thousands oversize could be the problem.
 
One thing you can try is to use a sharpie to colour up the whole case. Then try to chamber it. The sharpie colour will get rubbed off. This will tell you if the case is too tight elsewhere.
I'm in b.c. but if you want I can send you a couple of pieces of brass that have been full length sized in an rcbs 45-90 die.

Chris
 
Back
Top Bottom