Post your Beretta 1301 Tacticals

1ABNDT said:
I built another Boom boom.


IMG-20240514-100735452-2.jpg
Click to expand...

Very nice, I like it! Major changes from your earlier 1301? Did you cut the back support out of the Magpul AFG?
 
Ty Grain, same setup as the other, only difference is a "pro lifter". Yes, I removed the back of the AFG, it extends room for the loading stroke of the hand instead of running into the back of the AFG in its OEM form. Cheers
 
I've never tried an AFG, but I'm going to order an AFG2 to try on a MR1, so can remove the finger notch. If I remember right using it for support isn't relevant for you, if so I'd go with the hand stop. Less to snag on.
 
Grain said:
I've never tried an AFG, but I'm going to order an AFG2 to try on a MR1, so can remove the finger notch. If I remember right using it for support isn't relevant for you, if so I'd go with the hand stop. Less to snag on.
Click to expand...



You are correct Grain, ty for the input. If you like you can PM me your address & you can have my AFG if you wish. Cheers
 
embed

Think I'm done tinkering with it. Made it into a Comp Pro; upgraded bolt release, Comp Pro lifter, Kickoff stock, Aridus V2 foregrip, Tac Ord bolt handle, Limbsaver pad, Nordic Components mag ext, HiViz sight, Trulock ext chokes, and a Magpul barrel clamp. The blue Pro receiver was not for me.
 
Last edited:
Very nice, loving the kick off stock "plush" & the straight black.

"Lord Vader, your shotgun".

What Magpul clamp is that? Model.
 
Thanks. The Magpul clamp is MAG508, has QD cups both sides installed that way. Used to have a Nordic Components clamp on it, but was a poor fit, pushed the extended mag tube away from the barrel.
 
I didn't like the blue/black on the 1301 comp pro so I cerakoted it in OD and a 3 colour digital camo. No other upgrades besides a Tacord RMR mount and a Holosun 507 pro
IMG_3372.jpg
 
You must log in or register to reply here.
Back
Top Bottom