Project Update - Norinco M1911A1-C

sixty9santa

sixty9santa

CGN Ultra frequent flyer
Rating - 100%
36   0   0
So I had some time, about an hour, to spare from studying and this is what I did to my Nork slide:

IMG_1128.jpg


IMG_1133.jpg


Also notice the nice french cut and the ejection port (wanted to do something different:runaway: )
Some more of what I've done yet far from complete:

IMG_1151.jpg


IMG_1153.jpg


I've also tightened the slide to frame and polished up the inside of the dust cover.
The bobbing of the grip safety is also far from complete. The internals are McCormick and all the pins are Ed Brown.
I have yet to install the Trijicon front sight and the LPA adjustable rear sight.
Some more mods to the slide and frame are to be done including making a bobbed main sping housing and thus chopping the frame as well.

Not much, but it's a start.
Saving up for an air brush (if anyone has a good one for sale please do let me know) and then Armacoat.
Any other suggestions?
What would you do?
 
Last edited:
Sounds like you are well set up to do major sculpting.:)

I'd go for a bobtail modification ala Ed Brown Kobra Carry:dancingbanana:
 
--Terry-- said:
A non-reflective flat top would be a nice. But I guess it is hard to do...
Click to expand...


Not at all, I'm just waiting to drop the sights in (when the dovetail cutters arrive) and then I'll serrate the top!

beltfed said:
Sounds like you are well set up to do major sculpting.:)

I'd go for a bobtail modification ala Ed Brown Kobra Carry:dancingbanana:
Click to expand...


I just need time to make a main spring housing since 70-75USD for an Ed Brown MSH is expensive on a student budget.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom