Quad rail for a 10.5

MG4A6

MG4A6

Regular
Rating - 100%
22   0   0
Location
Calgary
So I bought an MG4A6(AR variant) with a 10.5 inch barrel and now I would like to dress it up a bit. I am looking for a quad rail to replace the fore end, the problem is I am also looking for a Eotech 557 AR.223 and a EoTech 3X.FTS and they both will not fit on the rail that the gun came with soooo I need a quad rail that extends on to the receiver to make it all the same height for the sights. I seen a Voltor rail system like that but they cannot ship it to Canada.
I've search the net for hours trying to find a place that could do all this for me but to no aval. Does anybody have any ideas or know of any stores that could do all this for me? Thanx
 
I would get the samason free float rail that daves surplus is selling, great product and they have some in stock last time i heard, if not try GADGET or ARWEN ACE on this forum and they might be able to get you something nice.
 
+1 on the Daniel Defense Omega Rail

uninterrupted top rail, lightweight and easy to install. I got one and i can easily recommend it.

Wolverine Supplies should also carry them
 
I was at the shooting edge today looking for this stuff but they had none of it and could not get any of it for me and if they did it would be really expensive.
A nice employee gave me a list of places to check out though and thats how I found this place. I will take a look at the suggested places for the rails but what about the Eotech? From what I read so far acquiring these are going to be a problem.
 
That Daniel Defense Omega rail looks nice but how do I find out if it's going to be level with the stock pic rail already on the rifle?
 
re

check out eBAY.com as they have tons of Knights Armaments RIS/RAS rails for your application. I have bought three RAS rails (two for M4 carbines and 1 for M16A4) with no problems. Knights are by far the best as the others are mostly commercial grade garbage.
 
MG4A6 said:
I was at the shooting edge today looking for this stuff but they had none of it and could not get any of it for me and if they did it would be really expensive.
A nice employee gave me a list of places to check out though and thats how I found this place. I will take a look at the suggested places for the rails but what about the Eotech? From what I read so far acquiring these are going to be a problem.
Click to expand...

Give Target Sports a call (contact details listed above in dealer sponsor link).

I believe they had a couple in stock.
 
MG4A6 said:
That Daniel Defense Omega rail looks nice but how do I find out if it's going to be level with the stock pic rail already on the rifle?
Click to expand...

It'll line up just fine. Its not UTG or airsoft crap. If you're worried, turn your upper upside down on a flat surface and install it. If you have a scope mount you can mount it half and half to bridge the receiver and the rail prior to tightening.

TDC
 
The Troy lite does require the removal of the D ring. You can do it yourself with the tools. The DD Omega requires the removal of the handguards and is 100% drop in. About 20 minutes.

TDC
 
You must log in or register to reply here.
Back
Top Bottom