Removing stock from CZ858 - What friggin size of screwdriver?!!

[pa]

I used this giant screwdriver from Lee Valley. With the receiver in a vise you can push your body weight into the screwdriver end while turning. The shaft has four flat sides so you can get a wrench on there for added torque. Princess Auto might have a similar screwdriver too.

Good Luck.


htt p://www.leevalley.com/us/wood/page.aspx?p=32511&cat=1,43411,43417&ap=1

 

[mp5k]

I do lots so i made the ultimate tool. Works awesome.

One more time, i have used this tool to remove dozens of CZ stocks by myself, i have never had one take more than 3 or 4 hits to remove, its an impact driver with a socket to fit the chisel, i ground the chisel to fit the slot. Done...