Ruger Blackhawk...assembly problems

[scubarod]

Hi all....Iam new here!!! i have a question, I have a .357 Ruger Blackhawk. im missing/misplaced a small pin that holds the trigger spring. the pin part number is KXR01400. can this part. here is an exploded view of the gun.

I also cannot get this thing back together...is there a trick to it?


Thanks

Rod

 

[frward]

you have to #### the hammer to be able to install this pin

 

[chemo]

good luck buddy, that spring is a son of a ##### to work with, when i installed my hogue grip removed that pin, the hammer spring and the internal lock thinknig the hogue assembly would fit. it didnt. had a hard ####ing time putting everything back together, in the end a trimmed a hair in the frame and it did fit

 

[scubarod]

I know...i have tried and no go. i need to find someone here is saskatoon that can help me out. do any of you know if i can get the rolled pin here is Canada???


Rod

 

[Scott_N]

I know...i have tried and no go. i need to find someone here is saskatoon that can help me out. do any of you know if i can get the rolled pin here is Canada???


Rod

You can probably get the pin here, they are Ruger's Canadian repair depot.

Location Snap Shots inc.
CANADIAN REPAIR STATION
650 Rang Roy
Sainte Martine, Quebec J0S 1V0
CANADA
Email: snapshots@videotron.ca
Tel. # 450-427-0052
Fax # 450-427-0498

 

[scubarod]

Thanks Scott

 

[ruffbird]

That is the sping pin that lines up the grips to the grip frame. Should be able to find one at a good hardware store & cut to length if you need to!

The width of the frame & the depth of the 2 alignment holes in the grips = the pin length....should be about 3/4".

 

[scubarod]

That is the sping pin that lines up the grips to the grip frame. Should be able to find one at a good hardware store & cut to length if you need to!

The width of the frame & the depth of the 2 alignment holes in the grips = the pin length....should be about 3/4".

great idea, thanks!!!!!



Rod