Most of us usually shoot a lower score on the Mover, compared to the Deliberate or the Snap.
Being an experienced shooter, I have an idea as to how much ‘lead' is required at each distance. With a rifle shooting 2400 fps to 2900 fps, the lead (for me) is approximately:
100 yards – 1 inch.
200 yards – 8 inches
300 yards - 14 inches.
These numbers are according to my eye and my reflexes. You might need to use a different set of leads to make it work for you.
Technique. We know the target will pop up and then walk across the middle of our lane. So take aim in the center of the lane, and when you see the target coming, adjust the elevation so the horizontal cross hair is on the bull. Then, when the target walks to the right lead place, fire. This is called the ambush method, and is easy and accurate.
Sighting shots. As I said, “lead” is in the eye and finger of the beholder. We get one sighting shot in each direction. At 100, fire the sighters as the target bull crosses the vertical cross hair. That is, shoot dead center. You won’t miss. The shot should hit behind the bull. Note how much, and that is your lead amount. Probably a very small amount.
I see a fair number of misses at 200 and 300. There is no reason to get a miss. If you fire a shot at the leading edge, you will get a hit. Probably a bit in front of the bull. That is, the leading edge is a bit too much lead.
On the sighter at 200 and 300, fire at the leading edge and note if the hit is in front of the bull or behind it. Take the same shot in both directions, and then decide if you need a bit more or less lead than the leading edge.
At the last match I was shooting a 30-30 at 100 yards. My ammo was plated lead bullets with a mild load, almost 1000 fps slower than usual. I knew I would need more lead, so I fired at the leading edge. That turned out to be about right, but all my shots were in the crotch…
Being an experienced shooter, I have an idea as to how much ‘lead' is required at each distance. With a rifle shooting 2400 fps to 2900 fps, the lead (for me) is approximately:
100 yards – 1 inch.
200 yards – 8 inches
300 yards - 14 inches.
These numbers are according to my eye and my reflexes. You might need to use a different set of leads to make it work for you.
Technique. We know the target will pop up and then walk across the middle of our lane. So take aim in the center of the lane, and when you see the target coming, adjust the elevation so the horizontal cross hair is on the bull. Then, when the target walks to the right lead place, fire. This is called the ambush method, and is easy and accurate.
Sighting shots. As I said, “lead” is in the eye and finger of the beholder. We get one sighting shot in each direction. At 100, fire the sighters as the target bull crosses the vertical cross hair. That is, shoot dead center. You won’t miss. The shot should hit behind the bull. Note how much, and that is your lead amount. Probably a very small amount.
I see a fair number of misses at 200 and 300. There is no reason to get a miss. If you fire a shot at the leading edge, you will get a hit. Probably a bit in front of the bull. That is, the leading edge is a bit too much lead.
On the sighter at 200 and 300, fire at the leading edge and note if the hit is in front of the bull or behind it. Take the same shot in both directions, and then decide if you need a bit more or less lead than the leading edge.
At the last match I was shooting a 30-30 at 100 yards. My ammo was plated lead bullets with a mild load, almost 1000 fps slower than usual. I knew I would need more lead, so I fired at the leading edge. That turned out to be about right, but all my shots were in the crotch…


















































