Hi, I have tried some searching online but can't find anywhere to buy a slotted bit socket for removing cz 858 fixed stock and installing folding stock. I am not sure what size of bit I need for the stock screw either, I used my callipers on the folding stock screw and got 0.087 - 0.090 inches for width of screw slot. But it seems slotted bits are measured in terms of screw head diameter.
Slotted bit socket for removing cz 858 stock
- Thread starter futa_mill
- Start date
Is this the info you're looking for?
Hopefully it shows up as a table.
It would be fastener size 0-1 if this is the info you need.
Screw Head - Slotted.svg
Slot drive tool and fastener sizes[5]
Blade width Fastener size
3⁄32 in (2.4 mm) 0–1
1⁄8 in (3.2 mm) 2
5⁄32 in (4.0 mm) 3
3⁄16 in (4.8 mm) 4–5
1⁄4 in (6.4 mm) 6–7
5⁄16 in (7.9 mm) 8–10
3⁄8 in (9.5 mm) 12–14
7⁄16 in (11 mm) 16–18
1⁄2 in (13 mm) 18–24
Hopefully it shows up as a table.
It would be fastener size 0-1 if this is the info you need.
Screw Head - Slotted.svg
Slot drive tool and fastener sizes[5]
Blade width Fastener size
3⁄32 in (2.4 mm) 0–1
1⁄8 in (3.2 mm) 2
5⁄32 in (4.0 mm) 3
3⁄16 in (4.8 mm) 4–5
1⁄4 in (6.4 mm) 6–7
5⁄16 in (7.9 mm) 8–10
3⁄8 in (9.5 mm) 12–14
7⁄16 in (11 mm) 16–18
1⁄2 in (13 mm) 18–24
This is all I did.
These are torqued down pretty good. My friend and I bought the largest screwdriver we could find and couldn't get it to budge (wasn't big enough and not enough leverage). Bought a large screwdriver type socket online and it came off. It looked like this:
These are torqued down pretty good. My friend and I bought the largest screwdriver we could find and couldn't get it to budge (wasn't big enough and not enough leverage). Bought a large screwdriver type socket online and it came off. It looked like this:
That is exactly what I am looking for, mind sharing where you found it.
These are torqued down pretty good. My friend and I bought the largest screwdriver we could find and couldn't get it to budge (wasn't big enough and not enough leverage). Bought a large screwdriver type socket online and it came off. It looked like this:
Looks like these are called drag link sockets.
Long time ago but I'm guessing Rock Auto... it has an unusual name too, which I forget.
FreedomIsn'tFree
CGN Ultra frequent flyer
- Location
- Republic of Buffalo.
Yes it does.
I have changed my fair share
Just use for penetration oil from the receiver side and give the screw driver a few good wacks with a hammer to loosen it
Shawn
