Spectre Ballistics Light Practical Carbine - NR Receiver Set

[tiriaq]

Upper; lower; bolt carrier; bolt handle.

 

[Darkw]

Am I the only one looking for a 7.62x25 version of this?

This has my immediate attention.

 

[jhnvan]

Upper; lower; bolt carrier; bolt handle.

Thank you!

 

[Gatehouse]

What mags would you use for a 762x25?

 

[Gatehouse]

Is there any reason why you couldn't use a delta ring, set it up like an M4? I assume it will be fine but thought I would ask.

 

[Kamikaze11]

I didn’t read everything , but could you install the charging handle on the left side for a lefty ?

 

[tiriaq]

I didn’t read everything , but could you install the charging handle on the left side for a lefty ?

Yes, right or left.

 

[Shorerider]

Is there any reason why you couldn't use a delta ring, set it up like an M4? I assume it will be fine but thought I would ask.

You’d just have to plug the gas port so you can use the front sight gas block.

 

[ChiliDawg]

Is there any reason why you couldn't use a delta ring, set it up like an M4? I assume it will be fine but thought I would ask.

That’s what I have too. Is there any reason I couldn’t flatten the gas tube and roll it a turn or two then pin it back in place upside down?

 

[tiriaq]

Cut it off, turn it over, reinstall.

 

[ChiliDawg]

Does anyone make a barrel wrench that doesn’t require you to remove the front sight.

 

[Geoff B]

That’s what I have too. Is there any reason I couldn’t flatten the gas tube and roll it a turn or two then pin it back in place upside down?

Why damage your current set-up? There is a two-year window for this stupidity to play out, so why not relax, get your LPC receiver set and find some AR parts that don't have to be permanently altered?
I want to try converting an NEA 10.5" AR to see how it will work out. I don't want to alter a more costly rifle if it turns out that I don't have to, or that I don't like the LPC. (I think that I will like the LPC)

 

[tiriaq]

Does anyone make a barrel wrench that doesn’t require you to remove the front sight.

Most barrel vises are two piece, a front sight base isn't an issue.

 

[tiriaq]

That’s what I have too. Is there any reason I couldn’t flatten the gas tube and roll it a turn or two then pin it back in place upside down?

A gas tube extends into the AR upper receiver. Couldn't be installed in the LPC receiver.
A little solid peg could replace the gas tube, and be pinned in place to close off the hole where the gas tube was.

 

[ChiliDawg]

I have a barrel wrench now but I need to remove the front sight to use it.

 

[TheCyaba]

I have a barrel wrench now but I need to remove the front sight to use it.

I got one from Amazon with a open end and have been using it for years was like $20

 

[Gatehouse]

 

[Levon12345]

What mags would you use for a 762x25?

https://www.canadiangunnutz.com/forum/showthread.php/1913524-A-pistol-calibre-AR-in-7-62x25!/page8

For your consideration.

 

[Geoff B]

$79 us

 

[Patriot762x51]

is there a 308 in the works ?. And in the 223 size can i use a standard ar BCG ?