Tactical Imports SRC-45

Long barrel. I have the short .410 already

I don’t know how to check for this. Looking down the cylinder end I can’t see any rifling, from the muzzle it looks normal 🤷

It is very light weight.
Thanks, if you can’t see the rifling from the back looking in it most likely has similar throat as the .410’s. Run a tight patch through the barrel and you will notice when the rifling ends it will go easy, you could also try putting a bullet in the back of the barrel and see how deep it goes in.
Think they do this to control the blast coming out between cylinder and barrel, you get a fairly good gas escape around the bullet before it hits the rifling, wondering if this will affect the accuracy
 
Put some 45ACP down the pipe. It’s a little fiddly using the moon clips. It’s almost like there the cylinder doesn’t swing out far enough for the empties and the moon clip to eject smoothly.

I found the trick is to keep pressure on the ejector and rotate the cylinder, allowing the moon clip to find its own way to clear the receiver.

There won’t be any speed reloads just yet with this thing.

What is astonishing is how light this rifle is. Like .30 carbine light. I wish it had sling swivels but they’d install easy enough
 
Okay. Mine is officially broken.

Cylinder won’t close

Update to the fastest fix in the world. My ejector rod had come loose. It’s a left hand thread for those wondering. Tighten it down and keep shooting.
 
Back
Top Bottom