The AK- SKS kit ( little update post 440 2015-03-19)( less ABS more wood and metal)

Sure has come a long way from the first post. I wonder how it would look and balance with what this guy has done for the trigger group and pistol grip. This could possibly allow for a better length of pull and cheek rest.

http://www.canadiangunnutz.com/forum/showthread.php/1232492-A-Modernized-SKS

WmMcLeod said:
Some close-up photos showing that the pistol grip is attached to the trigger group frame, and hopefully providing a better view of the safety which is obscured in the video. Also, i'd like to note that the magazine retention system does not rely on the stock whatsoever


IMG_6652.JPG


IMG_6651.JPG


There are some differences between this function-test prototype and the final design.
First, the trigger used will be the factory trigger, connected by a linkage, while this is a single piece extended through the pistol grip nut.
The magazine retention tabs will be located on the trigger group so that the rifle breaks down exactly like an un-modified SKS.
The safety lever will be ambidextrous, with tabs on both sides of the pistol grip.
The trigger guard magazine release has been redesigned to simplify manufacture and increase ergonomics.
Click to expand...
 
Last edited:
it would change anything on my stock because the trunnion that hold everything go at the end of the receiver , in not really a fan of that trigger modification

if we didnt have those stupid law of 18.5 inch barrel to be non-restricted i would probable chop the barrel shorter
 
Yes it's a great proof of design, I wasn't laughing at your design, but was laughing at the way he said it.
It has to start somewhere, and at least your using your head and not just your fingers :)
Cheers
Brian
 
You must log in or register to reply here.
Back
Top Bottom