the trigger was moved significantly back before it went off - enough that it reached the stage where one teaching it would say - take up the slack, then mash the trigger - he was at he wall there - zoom in and you will see it . move it a mm and it wont. its not fully cocked when the trigger is forward. it is a DA trigger pull in that it cocfks and fires with one press of the trigger.
The SIG Sauer P320 Has Never Been Good
- Thread starter 870P
- Start date
Yes the whole thing was interesting but a meaningless demonstration in terms of real world hazard. Other than the Sig, every gun had to have its trigger brought to and held on the trembling point of firing.
There's a lot of positives in traditional DA/SA pistols. The ability to thumb down on the lowered hammer while you re-holster is a big safety plus as you will feel the hammer start to rise if something is snagged in your trigger guard.
SIG226 or S&W 3rd Gen are examples.
SIG226 or S&W 3rd Gen are examples.
1riot1ranger
CGN Regular
- Location
- Calgary, AB
I tried to replicate the Wyoming Gun Project P320 test on my P320 X5. With the trigger depressed 1-2 mm, I couldn’t get the pistol to fire no matter how hard I worked the slide into the frame. If the trigger was very nearly at the sear-release point (around 1mm from breaking), I could get it to go off by pressing the front of the slide into the frame with thumb/finger pressure.
A sample size of 1 is statistically insignificant, but there is some evidence to suggest that it’s not a universal issue.
(I have no idea what the TriggerSmart test it trying to prove…. If you move the trigger completely to the rear and manipulate the slide, it makes sense to me that the pistol might fire as the sear/striker engagement doesn’t have much going on at that point. You’ve also disarmed the safety mechanism on most striker-fired pistols by depressing the trigger that far. I don’t see what this test is trying to accomplish as the concern is these pistols going off in holsters when the trigger is *not* depressed. The argument against the 320 is that the trigger could move *slightly* and frame/slide movement in a holster during flexing could make the pistol discharge. That’s what the Wyoming Gun Project video showed and that’s what other YouTubers have replicated. I couldn’t replicate the same results with my pistol. YMMV.)
A sample size of 1 is statistically insignificant, but there is some evidence to suggest that it’s not a universal issue.
(I have no idea what the TriggerSmart test it trying to prove…. If you move the trigger completely to the rear and manipulate the slide, it makes sense to me that the pistol might fire as the sear/striker engagement doesn’t have much going on at that point. You’ve also disarmed the safety mechanism on most striker-fired pistols by depressing the trigger that far. I don’t see what this test is trying to accomplish as the concern is these pistols going off in holsters when the trigger is *not* depressed. The argument against the 320 is that the trigger could move *slightly* and frame/slide movement in a holster during flexing could make the pistol discharge. That’s what the Wyoming Gun Project video showed and that’s what other YouTubers have replicated. I couldn’t replicate the same results with my pistol. YMMV.)
Any other Glock owners spent the weekend trying to get that slide to move enough to get a "click" out of manipulating it with the trigger at various tensions?
At least with my gen3, there is not enough play in the slide to get it to do anything unusual, there is just no wiggle happening for it to work with.
At least with my gen3, there is not enough play in the slide to get it to do anything unusual, there is just no wiggle happening for it to work with.
steamy teabag
CGN Ultra frequent flyer
- Location
- Inside Carneys Reich
Bad production run maybe.
