A little late, but it is:
-Pull back bolt to #### it, release the bolt
-Insert empty magazine
-Pull trigger, safety must be off and magazine must be in
-Remove magazine
-Pull out the mainspring housing (at back of grip) latch, swing it upwards, then, while holding this assembly with your fingers close to the grip, pull downards to remove the housing
-Point muzzle upwards, pull the trigger, catch bolt as it falls out.
-Pull barrel assembly off the grip
Reassembly
-Place barrel assembly back on grip
-Slide bolt back in, making sure that the hammer (squareish pice of metal when looking through where the bolt goes) is down.
-Point gun muzzle down, push the hammer forward and inwards to give the mainspring housing space to move
-Re-insert mainspring housing assembly through the hole in the bolt
NOW THIS IS WHERE THE MANUAL ####S IT UP
-Insert empty magazine
*Instructions are back to being correct now
-Point muzzle up, pull trigger
#### UP AGAIN
-Remove magazine
*Back to being correct again
-Swing mainspring housing back into place
The manual has it all correct up until the part where you're supposed to point the muzzle upwards, pull the trigger, and swing the housing back in. If you don't insert a mag before you pull the trigger, be prepared to have the mainspring housing fall out over and over. Hope this helps.
-Pull back bolt to #### it, release the bolt
-Insert empty magazine
-Pull trigger, safety must be off and magazine must be in
-Remove magazine
-Pull out the mainspring housing (at back of grip) latch, swing it upwards, then, while holding this assembly with your fingers close to the grip, pull downards to remove the housing
-Point muzzle upwards, pull the trigger, catch bolt as it falls out.
-Pull barrel assembly off the grip
Reassembly
-Place barrel assembly back on grip
-Slide bolt back in, making sure that the hammer (squareish pice of metal when looking through where the bolt goes) is down.
-Point gun muzzle down, push the hammer forward and inwards to give the mainspring housing space to move
-Re-insert mainspring housing assembly through the hole in the bolt
NOW THIS IS WHERE THE MANUAL ####S IT UP
-Insert empty magazine
*Instructions are back to being correct now
-Point muzzle up, pull trigger
#### UP AGAIN
-Remove magazine
*Back to being correct again
-Swing mainspring housing back into place
The manual has it all correct up until the part where you're supposed to point the muzzle upwards, pull the trigger, and swing the housing back in. If you don't insert a mag before you pull the trigger, be prepared to have the mainspring housing fall out over and over. Hope this helps.