UTAS UTS-15 Shotguns and Accessories Now Available!

Took these with my iphone the day I got it, picture quality isnt the best. Im at camp now so I cant take anymore till the weekend but I plan to shoot a video or 2 with it on friday.

dQ9wAJ5.jpg

bRDwDB9.jpg

xgKxyFZ.png

Had a scratch on the camo, not sure if I did it or not so I took a pic just incase. Its on the side at its highest point so I probably dinged it on my table I'm not sure. Gives a good close up of the camo print at least. But I think I'll have to be delicate with placing it down and I probably will only let it rest in my case. However, I'm sure this this is a common issue with all camo prints.
Te6xQEn.jpg
 
Last edited:
Put about 150 rounds through it today. Had jamming issues and had to eject unfired rounds 3 times. The only times it jammed was when we were attempting to push through 10-15 rounds in quick succesion. Firing normally caused no issues and we were only using cheap brand target loads which probably contributed to the jams. The camo peeled a little on the front but you really have to look closely to see it. The peeling was right where the pump locked so I guess its to be expected and I'll report back if more peeling occurs. I think the jamming are most likely a result of not following through perfectly, I've heard the gun is picky about racking properly. Overall I'm satisfied with it and next week when my EOtech arrives I'll be able to shoot seriously. Today was just to prove it functioned properly and for the most part it has. Right now all faults are operator error until I get a chance to take it out a few more times.
 
Well it seems like the honeymoon is over already. Took it out for the second time only this time since I got my EOtech in I had slugs ready to go. Every single rough failed to eject and jammed, I had to take apart the gun 6 times to get the shell casing out. I assumed it was the slugs (Federal) so I switched back to the target loads and the same thing happened. I'm not sure what is going on I took it apart cleaned it and tried again and still the same issue. If I don't get it figured out by tomorrow it may be on its way back and I'll just find something else. I Hate to send it away since its such a nice looking gun but I don't need a $1700 paper weight.

Update: Not sure what the problem was but seems to be solved now. Cleaned it took it back and still had issues for first few rounds. I noticed a rough part of the plastic along the path that the action slides past which could have been causing the issue, possibly it needed to be worn down a bit because now it slides just fine. I will put a couple hundred more through it before I give my final verdict just to make sure this issue is done with.
 
Last edited:
the weight on these things is very misleading. the size of the gun you would think it was fairly heavy. then you pick it up and it is light as a feather. as cool as they are. i dont think i would want to shoot one for to long.
 
Laser Flashlight unit

The new design for the laser unit is impressive. Has a selector switch instead of a push button. Mounting requires drilling new holes in the composite frame but comes with a jig and drill bit for doing so. Will be mounting mine after work today. Thank you Wolverine! The updated version was definitely worth the wait.
 
Gunmetal said:
The new design for the laser unit is impressive. Has a selector switch instead of a push button. Mounting requires drilling new holes in the composite frame but comes with a jig and drill bit for doing so. Will be mounting mine after work today. Thank you Wolverine! The updated version was definitely worth the wait.
Click to expand...

I sent mine back the switch was loose and the light was flickering on and off. Also I liked the push button better as it dose not get snagged on stuff.
 
You must log in or register to reply here.
Back
Top Bottom