VLTOR+DLASK+ATRS+NEA+JP...= First complete built.
- Thread starter bilkathegerman
- Start date
bilkathegerman
Regular
very nice build! Ballpark total cost for this build (minus scope and rings of course)?
~2000$
bilkathegerman
Regular
Read all the posts and you will see a picture from a build with a 7,5", which in my opinion doesn t look good hence the 8,5"
bilkathegerman
Regular
I like slanted grips on longer handguards/barrels, I don't use the vertical grip like a tennis racquet I put my hand in front of it around the HG and use the grip like a rear stopping point. So my arm is not as extended as with a AFG. I don't know if it's clear but thats the best I can do.
- Location
- East of Home, West of the Rest
I read all the posts. Nothing confirmed that the rail was 9 inches from front of the upper to the opening of the rail. Hence why I asked the way I did. I didn't find any measurements online either. Could you give an accurate measurement of the entire rail from upper to opening?
I was looking at a 7.5 with 9 inch troy trx rail and a flaming pig or dlask MB. Your build might change my outlook on barrel length but I just want to be sure of the lengths your running with all around.
bilkathegerman
Regular
Yep it s a 9 inch handguard from receiver to end. IMHO your built will look a lot better with a 7,6" troy handguard, you can go on AR15 . com and check the Ar pistol picture thread (you don't need to register), it will give you plenty of examples. A 11.5" barrel with a 12" handguard also looks great.
bilkathegerman
Regular
Or instead of a big FH you could use a smaller one and go with a 10,5 or 11.5. Or even a barrel shroud and go for a 14,5.
- Location
- East of Home, West of the Rest
I did that with my 14.5 using a 13 inch rail. I had the 9 inch rail on it and replaced it with the 13 and used the standard birdcage. Def want the massive FH for the SBR. Oh the dilema of multiple ARs haha.
bilkathegerman
Regular
I hear you, I just can't stop.
