Who is using PVRI brass and what are your thoughts??

[Eaglelord17]

I personally think that Prvi should receive a medal of some sort for providing shooters of milsurp rifles in what used to be considered oddball calibers, a source of reasonably priced, good quality brass. My opinion only, others may have different mileage.

100% agree with this. If it wasn't for them making odd ball brass I wouldn't be shooting many of my milsurps in odd calibers (8mm Lebel, 6.5 Carcano, 8x50r Austrian (though I make this from there 8x56r case))

 

[Hitzy]

Decent brass for the price, i have some in .223, 7.62x39, 6.5x55, 7-08, and 8x57.
It's closer to Winchester in weight and quality I find then say Fed or Remington.
Use it with confidence.

 

[Barnes_270]

I use it in 9.3x62, 7.62x39, and 303 Brit. Excellent brass all round.

 

[scott_r]

Wish they would have it in .204 and 300 wsm...I give er rip.

 

[bassman]

Love it in my .22 Hornet

 

[ATOM]

It's my sole-source for .303 British. Among other things, the rim is a tad thicker than North American commercial brass, which helps with the typical Enfield headspacing issue. Good stuff.

 

[gps2]

Have been using PRVI brass for all kinds of mosin nagant loads and find it to be very consistent brass. Well worth it.

 

[Hitzy]

It's my sole-source for .303 British. Among other things, the rim is a tad thicker than North American commercial brass, which helps with the typical Enfield headspacing issue. Good stuff.

If you run out, check higginsons for Herters 303....good tough stuff at $21.50/50. Needs a good cleaning first though.

 

[Andy]

Starting using it when I stopped using Winchester. Tight primer pockets, high capacity, while being durable and consistent.