Reverse Fake Suppressor with Linear Compensator

Has anyone shot one yet?

I'm super paranoid about not having it centered. I have it tight on a washer but giving the eye test it's impossible to tell how centered it is with such a small margin.

How much bigger is the center hole compared to the muzzle?
 
langr said:
Has anyone shot one yet?

I'm super paranoid about not having it centered. I have it tight on a washer but giving the eye test it's impossible to tell how centered it is with such a small margin.

How much bigger is the center hole compared to the muzzle?
Click to expand...

The center hole is 0.25" diameter, or about 0.026" bigger than the bullet, assuming this is a 5.56 barrel.
 
Brooker1 said:
any chance of some .30 cal models?
Click to expand...

We are designing these up.

We have a choice whether to expand the rear hole to allow for heavy (0.875" outer diameter) barrels. Anyone care to comment?

As it is now I would leave it at 0.765" to keep a small gap around 0.75" barrels which seem to be the majority of the .30 barrel options that we stock.
 
True North Arms Corp said:
We are designing these up.

We have a choice whether to expand the rear hole to allow for heavy (0.875" outer diameter) barrels. Anyone care to comment?

As it is now I would leave it at 0.765" to keep a small gap around 0.75" barrels which seem to be the majority of the .30 barrel options that we stock.
Click to expand...

Well, it's great to have the option to fit it to a heavy barrel, but that might compromise the look on a standard barrel.
These are mostly for aesthetic compared to a normal linear after all.

I would hazard to guess those who run a heavier barrel are doing so for some special application like precision, and would be unlikely to want something like this.
 
Conte said:
Well, it's great to have the option to fit it to a heavy barrel, but that might compromise the look on a standard barrel.
These are mostly for aesthetic compared to a normal linear after all.

I would hazard to guess those who run a heavier barrel are doing so for some special application like precision, and would be unlikely to want something like this.
Click to expand...

That's a good point,
Thank you
 
True North Arms Corp said:
We are designing these up.

We have a choice whether to expand the rear hole to allow for heavy (0.875" outer diameter) barrels. Anyone care to comment?

As it is now I would leave it at 0.765" to keep a small gap around 0.75" barrels which seem to be the majority of the .30 barrel options that we stock.
Click to expand...

I was looking at putting one on a 17HMR (CZ457 Varmint), but it has a .866 OD barrel... I would be interested in a larger one for sure. Either that, or finding a way to trim some off the back until it fit...
 
Just an update, we're nearly out of stock of 1/2"-28 fake cans with linear comp. We are preparing another batch that will be around around late May and will include a 5/8"-24 option.
 
You must log in or register to reply here.
Back
Top Bottom