40-60 Marlin dies

[cooperod]

Looking for a set of 40-60 Marlin dies or Winchester 40-65 apparently work as well.
Is there another way around this loading? Dies seem difficult to find.
Any help would be appreciated!

 

[TheCounty]

Looking for a set of 40-60 Marlin dies or Winchester 40-65 apparently work as well.
Is there another way around this loading? Dies seem difficult to find.
Any help would be appreciated!

C&H Tool and Die
Great service and good price.
Recently got 25-20 Single Shot dies from them.
40-60 Marlin is in their list.
Cheers

 

[cooperod]

C&H Tool and Die
Great service and good price.
Recently got 25-20 Single Shot dies from them.
40-60 Marlin is in their list.
Cheers

Thank you. I just brought a chamber reamer in from PTG, Canadian Customs hit the $288 shipment with tariffs of $80, had it labeled as “Steel”. Was hoping to avoid a similar event, but may have to go this route eventually.

 

[slug]

Lee has made 40/65 dies in the past.
Perhaps, check with Higginson?

 

[cooperod]

Lee has made 40/65 dies in the past.
Perhaps, check with Higginson?

Thank you! Will reach out.

 

[Valiant]

Looking for a set of 40-60 Marlin dies or Winchester 40-65 apparently work as well.
Is there another way around this loading? Dies seem difficult to find.
Any help would be appreciated!

I would research how close another cartridge that u can get dies for are. Maybe you can neck size,expand and crimp with more popular dies

 

[cooperod]

I would research how close another cartridge that u can get dies for are. Maybe you can neck size,expand and crimp with more popular dies

This is part of that research piece.
Other than 40-60 and 40-65 to finish the process for chambering, options are limited. If I could find a chamber reamer could make a die as well.

 

[cooperod]

Thank you! Will reach out.

Higginson had some 40-65 win dies so good for that. Thanks! Now some brass…

 

[cooperod]

Still can't find any brass yet.
Anyone stumble upon any?

 

[DaveF]

I used to make 40-65 brass from Winchester 45-70 brass using Lyman 40-65 dies, and Lee resizing lube which was/is lanolin based.
I used Winchester brass as it was very slightly thinner walled than Remington, and this was before Starline brass was commonly available
I sized well-lubed brass initially using the seating die first as it's dimensions were slightly larger than the sizing die, and then sized it down fully in stages using the sizing die, rotating the brass in the shell holder as I did so.
Trying to do it in only one pass through the sizer alone usually didn't work very well and produced vertically creased/wrinkled necks.