alex_40cal
Member
- Location
- Vancity BC
50 Beowulf Metal Magazine Review
- Thread starter PrettyBoy
- Start date
Good review! I picked up 3 of them from Barton's as well. Alway get great service from those guys. I don't have any AR's, but I do use my tavor quite a bit at the range... Ok all the time lol. I was using pmags since I got it, they always functioned well, but I found never dropped free out of the tavor. I do like that these new 50 beo mags do drop free every single time, seat when full on a closed bolt (usually a decent smack is needed though), and feed 100 percent of the time. Only thing I don't like is that I burn through ammo 3 times as fast now when I do got to the range lol. I use mainly tacos on my PC, and they are a bit short in those for a clean draw, all I did was put a wedge into the pouch to raise the mags up and problem solved. Ammo is getting expensive so we will see if I want to pick up a few more or not.
- Location
- Southern ontario
I like aluminium in that it's easier on the mag well. Steel mags can have some really sharp edges and gouge the lower good if you aren't careful
I just got mine in the mail today. They are definitely not magnetic (if a magnet sticks its because it is sticking to the spring inside the magazine). The plastic wrap that it comes in is marked "05RD Beowulf AL" I assume the AL is for Aluminum. The follower is a black anti-tilt 5.56 style with the 5.56 marking removed. Have not had a chance to test them yet.
alex_40cal
Member
- Location
- Vancity BC
Good. I like C Products aluminum mags a lot.
When you say "5.56 marking removed", what do you mean?
When you say "5.56 marking removed", what do you mean?
That is for sure possible. I can say it didn't cross my mind that it could be sticking to the magnet.
That could be a problem. If that is seen as evidence to support that these mags are somehow converted from 5.56 mag.
Moe
I'll have an update to the original post in a couple minutes
whiteoutjeeper
CGN frequent flyer
- Location
- Calgary, Alberta
