KevinB said:Lets see,
I've run a M4 in Afghan and Iraq -- no problems -- but I guess yoru experience must be much more extensive.
How is that for a crash landing ?
KevinB said:Lets see,
I've run a M4 in Afghan and Iraq -- no problems -- but I guess yoru experience must be much more extensive.
KevinB said:Lets see,
I've run a M4 in Afghan and Iraq -- no problems -- but I guess yoru experience must be much more extensive.
GIXXER said:Although I don't know Kev personally ,I highly doubt you have better "real life" exp.
peckerwood said:Dont forget that the M43 ball fmj round overpenetrates...bad idea when dealing with potential hostage situation...hit the bad guy and the bullet continues out the body and hits a soccer mom or blue collar daddy.
If I am not mistaken it does the same thing with soft points and hollow points too.
Another point which not a lot of people have hit upon is that one of the other reliability factors in the AK, is because the casings are made from steel rather than brass. Considering how brutal the AK loading mech is to brass casings, they tend to bend at the neck because of this and sometimes jam up.
Leading into the next main point in the steel casing realm is the fact that the major suppliers of such steel casing ammunition for the M43, tend only to make FMJ ball...hollow point and soft point steel casing cartridges are not easy to come by for someone sourcing ammo through the RCMP or other LEO detachments.
![]()
redleg said:most centerfire rifle cartridges "over penetrate" people. It isn't a caliber issue so much as a bullet selection issue. If you are concerned, use the correct bullet.
7.62x39mm ammo is easy to obtain in HP, SP and even frangible flavours. It is however more expensive than most are willing to pay given the cheap surplus offerings available.
ancorp said:Hah, I of course, was kidding
Alex

Tango said:M4 = COLT
Reaper said:Kevin +100.. II talked to some UN types hit a close ranges in Afghanistan the AK rounds were stopped by Lvl IIIA soft armour, bigger isn't better sometimes.




























