P0WERWAGON
CGN Ultra frequent flyer
- Location
- burnaby BC كافر
i've tried to call three times in three days, no response, i've also sent three emails with the same result.
The guy is moving, I'd give him a break. Though he should have put up a voice message on the phone
Every time you fail to answer the phone, a customer goes to the competition.
Okay guys, I have a question....
What's the deal with the plastic hammer stop? what role does it play? more specifically, what does the little raised section do???
Is there a way to know if I have it in right? maybe some sort of function check?
I clearanced the hammer in order to install the plastic "hammer stop" but the little bar in the hammer touches the raised section of the plastic on the hammer stop...is this good or bad? Nothing else touches except that little "nub" on the plastic hammer stop
all help/advice is appreciated
A picture is worth a thousand words. Can you post some pics?
The only thing more disappointing than spending $200 on one of these things is the fact I bought two of these restricted paperweights!
The hole for the hammer pivot pin is not where it should be. I assembled it exactly as shown in the armorer DVD, the hammer is stiff as hell and will not go fully foreward. Also, the damn SEAR WILL NOT ENGAGE the hammer.
As someone else mentioned, the hammer will barely clear the hammer stop pin, leaving nearly no room for the hammer stop.
And to think I hesitated to buy an NP-34 when they were available, I've never had an evil Chinese gun be this much of a letdown!
I guess I'll have a crapload of spare parts waiting when CanAm gets the 9mm NP-58s in...I know they'll work.