Lynx 180B Upper Receiver Info Thread

So you mean this ???.

Left hand charge uppers are in stock now and ready to order.

Right hand charge uppers are finished, we just need to assemble them, do product photos and add them to the site. Should be ready to order tomorrow afternoon.
 
Match lower is built and now my upper is ordered.

I eagerly await your in-house upper components ��
This shall be a Kodiak-free build.

Side-note; has anyone run into issues with AR safety installs on the Lynx 180B Match lower?
I found my AR safety detent springs in both my Triggertech kit and Bushmaster LPK were too short. I had to put a spacer in the grip to have the detent sit high enough to actually engage the safety.

Also, less of an issue, but my triggertech safety barrel is too snug unfortunately, tolerance of maybe a couple thousandths too tight for it it seems, I can force it in but it won't rotate. Bushmaster safety barrel went in no problemo though. Contemplating taking some Emery cloth in a drill to the inside of the safety barrel holes on the lower to accomodate the triggertech safety, but don't want to #### with the finish so I haven't.
 
evonorth said:
Match lower is built and now my upper is ordered.

I eagerly await your in-house upper components ��
This shall be a Kodiak-free build.

Side-note; has anyone run into issues with AR safety installs on the Lynx 180B Match lower?
I found my AR safety detent springs in both my Triggertech kit and Bushmaster LPK were too short. I had to put a spacer in the grip to have the detent sit high enough to actually engage the safety.

Also, less of an issue, but my triggertech safety barrel is too snug unfortunately, tolerance of maybe a couple thousandths too tight for it it seems, I can force it in but it won't rotate. Bushmaster safety barrel went in no problemo though. Contemplating taking some Emery cloth in a drill to the inside of the safety barrel holes on the lower to accomodate the triggertech safety, but don't want to #### with the finish so I haven't.
Click to expand...

Yes, due to the AR180 geometry a spacer is needed to give the spring/detent the proper height. I had to do the same thing.

My triggertech safety was snug to install, however it rotates freely once installed.
 
Galvz said:
Yes, due to the AR180 geometry a spacer is needed to give the spring/detent the proper height. I had to do the same thing.

My triggertech safety was snug to install, however it rotates freely once installed.
Click to expand...

Damn. I can get it through the left snugly and it rotates, but once I get it through the other side it's like it's in cement. Unfortunate.
 
We still have right hand charge uppers in stock

i.php


20230129054802-5e5281e1-la.jpg
 
You must log in or register to reply here.
Back
Top Bottom