NEW TNA 3-GUN VR-66 12ga SHOTGUN is here!
- Thread starter True North Arms Corp
- Start date
- Location
- ON, North of GTA
I think maybe the oops got the vent rib barrel because TNA has em and maybe aren't moving as many.
Apparently the oops is a " vr66 receiver but the mag tube needed to be modified thus there is an exposed aluminum edge,not visible once the gun is together" Looks like "oops" also has opened loading port but std bolt and carrier.
Incidentally, when I ordered my VR66 I wanted the vent rib and requested they swap out the GRS barrel, which TNA obliged.
Mine did include the rear sight and pic rail which I removed a they obviously don't work with the vent rib/bead setup.
These make a good utility or 3gun setup but I might be posting mine up in the EE to fund another project.
Apparently the oops is a " vr66 receiver but the mag tube needed to be modified thus there is an exposed aluminum edge,not visible once the gun is together" Looks like "oops" also has opened loading port but std bolt and carrier.
Incidentally, when I ordered my VR66 I wanted the vent rib and requested they swap out the GRS barrel, which TNA obliged.
Mine did include the rear sight and pic rail which I removed a they obviously don't work with the vent rib/bead setup.
These make a good utility or 3gun setup but I might be posting mine up in the EE to fund another project.
Any Benelli Crio choke will work in these( not Crio Plus) so look for a rifled Crio choke. Have a look on the Stoeger Canada sight, I know they carry some
- Location
- ON, North of GTA
I hadn't noticed that but mag capacity seems as good a reason as any.
So if 3" pinned at 5.9 shells can fit 6 2 3/4" shells do we think it's possible to squeeze 7 pinned for 5.9 3 1/2"'s?
So if 3" pinned at 5.9 shells can fit 6 2 3/4" shells do we think it's possible to squeeze 7 pinned for 5.9 3 1/2"'s?
Will the action cycle 3.5" shells? If the barrel says it is chambered for 3.5" then that is what the mag capacity should be measured with.
Mark
I'll see if I can sell my brother on the oops guns.
- Location
- ON, North of GTA
Barrels apparently no but I believe pretty much everything else is.
I didn't try putting a Benelli barrel on mine, but I did try putting a VR66 barrel on a Benelli. There is a small nub on the top of the barrel that fits into its mate on the receiver. If you lightly run a mill bastage file on the either side of the VR barrels nub, you can get them to fit. Does not need much taken off.
CanuckShooter
CGN frequent flyer
Received my bare bones model last week. Cleaned and oiled it. Took it out yesterday. Fifty rounds each of Challenger high velocity target, Rio high velocity target, and Federal Top Gun (1180fps) target loads, not in any particular order. Not one malfunction of any kind. Pretty impressive so far for $399 on sale.
