Norinco Type 97 $849 FREE SHIPPING

[Clobbersauras]

CanAm, Will you be importing replacement parts for the 97? Bolts, barrels, springs, firing unit, etc?

Would also like to see some spare magazine release units so I could do some experimenting

 

[CanAm]

Let me know what you want, we can bring them in.

 

[John Spartan]

A basic spare parts kit would be nice - parts would be the ones most likely to wear out or break down.

 

[KK1]

A basic spare parts kit would be nice - parts would be the ones most likely to wear out or break down.

Sounds like a good idea to me.

 

[Jay]

A basic spare parts kit would be nice - parts would be the ones most likely to wear out or break down.

+1, I would buy a spare parts kit, no question. This was one of the reasons I "hesitated" in my purchase, I didn't want to get "stuck" without access to parts...

Thanks CanAm

Cheers
Jay

 

[Deckard]

Let me know what you want, we can bring them in.

Something from the factory marked RESCUE SIGNAL DEVICE: FOR USE WITH SIGNAL FLARES.

 

[sillymike]

Speaking of spare parts... little goodie bags with spare firing pin/springs/extractors would be nice... Kind of like what the Russian used to do.

 

[ponts]

A basic spare parts kit would be nice - parts would be the ones most likely to wear out or break down.

Yes a spare parts kit is a must!! I would buy one too.

 

[hori]

what about the the chinese scope like Lever carries? I would like to have the original to make it complete regardless if there are better on the market. Can you look into that for us please also?

 

[CanAm]

We are working on scopes. But the "official" scope is a rip-off, frankly. Even Norc says the factory is out to lunch on their pricing.

 

[KK1]

Any ideas on a picatinny rail system for mounting solutions.

For the barrel, or.

Mounting picatinny rails to the foregrip.

 

[Clobbersauras]

Let me know what you want, we can bring them in.

For me a spare bolt/firing pin, striker and spring assembly, and firing unit.

Barrels eventually.

 

[Deckard]

Norinco AR drum.

 

[Clobbersauras]

CanAm - do you know if the T97 barrels are hammer forged?

 

[CanAm]

Norinco AR drum.

5 rds?

 

[CanAm]

CanAm - do you know if the T97 barrels are hammer forged?

Yes, Chongqing has a GFM machine.

 

[Deckard]

drum

5 rds?

Of course it is 5 round, but I want my 97 to look like this...sort of...

http://world.guns.ru/machine/mg44-e.htm

 

[ponts]

Of course it is 5 round, but I want my 97 to look like this...sort of...

http://world.guns.ru/machine/mg44-e.htm

x2!!!

 

[Clobbersauras]

Yes, Chongqing has a GFM machine.

Great, thanks!

 

[myriflemylife]

Let me know what you want, we can bring them in.

I want the bayonet