Short barrels for Ruger 10/22 (8in, 10in, 12in)
- Thread starter Parts Only Canada
- Start date
Haven't spent much time searching for longer options. In your opinion is there demand for this? It seems most of the long range guys are running other platforms (not 10/22).
Christopher Tennant
Member
- Location
- Okanagan Valley, BC
12" for sure. If they come in take-down options even better.
A few guys have expressed interest in 12in. So far we are leaning towards the first batch being 12 inchers. Maybe also some 10 inch ones. Depending on how many people express interest.
They do
they might be a little over the 300 mark. But can be sourced.Anything 12”-14” provides similar utility.
Below that is greater blast and velocity loss. It should be long enough to be legally hunt-worthy for the BC folks out there. 13” would be great and still very handy and packable even with a linear compensator. I’ve handled 12” barrel models and I don’t think a 13/14” would be any less handy.
18.5” is noticeably less handy and packable though.
Below that is greater blast and velocity loss. It should be long enough to be legally hunt-worthy for the BC folks out there. 13” would be great and still very handy and packable even with a linear compensator. I’ve handled 12” barrel models and I don’t think a 13/14” would be any less handy.
18.5” is noticeably less handy and packable though.
We aren't looking at any 13 or 14inch models at this time, as the readily available options are 8, 10, and 12. Based on feedback I think 12 will be coming soon as well as probably 10in too.
They'd be slightly more money than the non-TD version. Probably around 10% more. If you know anyone else looking for short TD, tell them to post here! The more feedback we get the more likely something is to happen.
I have a 12” that i purchased a few months ago here in canada.
It works very well BUT the tenon was not a tight fit in the SBI receiver i am using.
SBI has a set screw above and i have a dlask adjustable vblock below and nothing has shaken loose but i wud have preferred a tighter fit.
Its going to move to another receiver soon so we will see if thats tighter.
Shoots well enough for me. (Minute of Centre Mass) but i havent tried good ammo in it to see what it can do.
It works very well BUT the tenon was not a tight fit in the SBI receiver i am using.
SBI has a set screw above and i have a dlask adjustable vblock below and nothing has shaken loose but i wud have preferred a tighter fit.
Its going to move to another receiver soon so we will see if thats tighter.
Shoots well enough for me. (Minute of Centre Mass) but i havent tried good ammo in it to see what it can do.
If I was going to get a 12 Inch takedown barrel, I'd prefer to order it with an extra Takedown Locking Block Mechanism so the option of switching barrels would be easier. I'd probably get a spare magpul backpacker foreend as well...
