SOLD OUT: TR-410 Micro

Empty casing, sorry
Had the same thing happen to me. Grab a ramrod or brass cleaning rod, put it into the cylinder up against the stuck casing (cylinder swung open), and smack it hard. Hit the rod with a mallet if you have to. It'll come free.

Then take cleaning patches soaked in oil and lubricate the inside of every chamber on the cylinder.
 
20260926_182609.jpg


Sh*t!
 
I applied heat before I tried ro remove it.

Edit. I had no intention to remove them permanently. I wanted them off to do a detailed cleaning after about 200 rounds fired.
 
Last edited:
My .45LC bullet is stuck, tried to poke it out without luck 😞. Extractor is jammed too.
I have same problem in one cylinder after firing, just knock out one at a time to see which cylinder. Give it a super good cleaning and make sure you clean behind extractor star. One of my cylinder has a deep machining scratch and when fired expands and gets caught up on it. Needs to be honed. But that would probably void warranty. As Deng577 said earlier try a good brushing and cleaning and oil. Should extract
 
20260927_145042.jpg

I removed the right side frame cover for further cleaning, and the circled piece fell out. Anyone have a parts diagram for the SR-45?
Anyone knows where that piece goes?
 
Here's the casing that was stuck in mine. You can see the rough marks on the brass too. This was the one that gave me trouble extracting.

20260929-101812.jpg
 
What's stuck on the side of the casing?
Scraped it off with my fingernail. The particles are actually shiny greenish/grey granules, so I’m thinking it may be unburnt or partially burnt powder mixed with carbon. The brass underneath looks smooth, doesn’t seem to be pitted.
 
Back
Top Bottom